Transport; Assembly; Preparatory Activities; Checking Delivery Content - Holzmann BF16V Mode D'emploi

A safety notice designed in this way indicates a potentially hazardous situation which,
if not avoided, may result in property damage.
Irrespective of all safety regulations, your common sense and appropriate technical
suitability/training are and will remain the most important safety factor for error-free operation of
the machine. Safe working primarily depends on you!

TRANSPORT

Damaged or insufficiently strong hoists and load slings can result in serious injury or
even death. Before use, therefore, check hoists and load slings for adequate load-
bearing capacity and perfect condition. Secure the loads carefully. Never stand under
suspended loads!
To ensure proper transport, observe the instructions and information on the transport packaging
regarding centre of gravity, attachment points, weight, means of transport to be used and the
prescribed transport position, etc.
Transport the machine in its packaging to the place of installation. To manoeuvre the machine in
the packaging, a pallet truck or forklift truck with the appropriate lifting force can be used, for
example. Ensure that the selected lifting equipment (crane, forklift, pallet truck, load sling, etc.) is in
perfect condition. Lifting and transporting the machine may only be carried out by qualified
personnel with appropriate training for the lifting equipment used.
1. Place the load slings around the machine to prevent it from slipping.
2. Place soft, non-slip materials between the load slings and the machine.
3. Align the load slings lengths so that the machine is horizontal and stable when lifted.
4. Bring the worktable into the maximum outermost position to the machine body in the
longitudinal axis.
5. Bring the worktable into centred position in the transverse axis.
6. Lock the machine completely.
7. The load slings must not touch the machine body, lever, etc.
8. Gently lift the machine to avoid shocks and load fluctuations and carefully transport it to the
installation site.

ASSEMBLY

17.1

Preparatory activities

17.1.1

Checking delivery content

Always note visible transport damage on the delivery note and check the machine immediately
after unpacking for transport damage or missing or damaged parts. Report any damage to the
machine or missing parts immediately to your retailer or freight forwarder.
17.1.2

Cleaning and lubrication

Before you install and commission the machine at the intended location, carefully remove the
anti-corrosion protection and grease residues.
Under no circumstances should you use nitro thinner or other cleaning agents that could attack
the machine's paint.
Oil bare machine parts (e.g. cross table, slides) with an acid-free lubricating oil.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
NOTE
WARNING
TRANSPORT
31
BF16V