Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
DISPOSAL
Observe the national waste disposal regulations. Never dispose of the machine,
machine components or equipment in residual waste. If necessary, contact your
local authorities for information on the disposal options available.
If you buy a new machine or an equivalent device from your specialist dealer, he
is obliged in certain countries to dispose of your old machine properly.
TROUBLESHOOTING
Danger due to electrical voltage! Manipulating the machine with the power supply up
may result in serious injury or death. Before carrying out any troubleshooting work,
always disconnect the machine from the power supply and secure it against
unintentional recommissioning.
Many possible sources of error can be excluded in advance if the machine is properly connected to
the mains.
If you are unable to carry out necessary repairs properly and/or do not have the required training,
always consult a specialist to solve the problem.
Fault
Machine does not start
Drill is decentered / run
unbalance / "wobbles"
Overheated engine
Tool smokes
Inaccurate drilling / milling
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
WARNING
Possible cause
Power supply incorrect
Defective switches
Defective motor
Fuse or contactor broken
Wobbles drill chuck
Spindle is worn out
Jaws are defective
Motor overload
Wrongratio speed / material
hardness / drill
Cone drilling profile
Cooling
Poor work fixing
Vibration of the machine
Wobbles chuck
Correction
Check all electrical connections
Exchange
Exchange
Change fuse, activate contactor
Chuck with timber, rubber
mallet hammer on them.
Replace the screw or ball
bearings
Replace drill chuck
Too much drill or milling
pressure
Excessive speed, reducing!
Sharpening
Milling / drilling with coolant
Clamp the workpiece new
Anchored firmly in the ground
see above further
DISPOSAL
42
BF16V
Publicité
Table des Matières
