RedMax LRT-EX200 Manuel D'utilisation page 4

Use approved protective gloves.
Noise emissions to the environment
according to European Directive
2000/14/EC and New South Wales
legislation "Protection of the Environment
Operations (Noise Control) Regulation
2017". Noise emission data can be found
on the machine label and in the Technical
data chapter.
Note:
Other symbols/decals on the product refer to
special certification requirements for certain markets.
Symbols on the product
WARNING: Be careful and use the
product correctly. This product can cause
serious injury or death to the operator or
others.
Read the operator's manual carefully and
make sure you understand the
instructions before you use this product.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection. Use approved eye
protection.
Note:
Other symbols/decals on the product refer to
special certification requirements for certain markets.
4
There is no electrical insulation in this product. If the product touches or comes near high
voltage power lines, it can cause serious injury or death to the operator. Electricity can move
between different objects by a curve. The higher the voltage, the longer the electricity can
move. Electricity can also move through branches and other objects, especially if the object
is wet. Always keep a distance at a minimum of 10 m/33 ft between the product and high
voltage power lines. Make sure that the power is off before you start the work near the power
lines. Keep a distance at a minimum of 15 m/50 ft to other persons or animals during the
operation.
There is no electrical insulation in this product. If the product touches or comes near high
voltage power lines, it can cause serious injury or death to the operator. Electricity can move
between different objects by a curve. The higher the voltage, the longer the electricity can
move. Electricity can also move through branches and other objects, especially if the object
is wet. Always keep a distance at a minimum of 10 m/33 ft between the product and high
voltage power lines. Make sure that the power is off before you start the work near the power
lines. Keep a distance at a minimum of 15 m/50 ft to other persons or animals during the
operation.
Use heavy-duty slip-resistant boots.
Stop the product fully before you touch the
cutting tool.
Keep all parts of your body away from the
hot surfaces.
Arrows which show limits for handle
position.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
1472 - 002 - 11.11.2020