General Power Tool Safety Warnings; Safety Instructions For Operation - RedMax LRT-EX200 Manuel D'utilisation

Cutting unit operating cycle, operation
time/idle time.
Max 3/10 sec
WARNING:
instructions, illustrations and specifications
provided with this power tool. Failure to
• If you encounter a situation where you are uncertain
how to proceed you should ask an expert. Contact
your dealer or your service workshop.
• Avoid all usage which you consider to be beyond
your capability.
• Cutting tool. Do not touch the tool without first,
switching off the engine/remove the battery.
• Never allow children to use the product.
• Ensure that no-one comes closer than 15 m while
you are working.
• Never allow anyone else to use the product without
first ensuring that they have understood the contents
of the operator's manual.
• Never work from a ladder, stool or any other raised
position that is not fully secured.
• Always ensure you have a safe and stable working
position.
18
DANGER - This product is not electrically insulated. If the product touches or comes close to
high-voltage power lines it could lead to death or serious bodily injury. Electricity can jump
from one point to another by arcing. The higher the voltage, the greater the distance electric-
ity can jump. Electricity can also travel through branches and other objects, especially if they
are wet. Always keep a distance of at least 10 m between the product and high-voltage pow-
er lines and/or any objects that are touching them. If have to work within this safe distance
you should always contact the relevant power company to make sure the power is switched
off before you start work.
The operator of the product must ensure, while working, that no persons or animals come
closer than 15 meters.

General power tool safety warnings

Read all safety warnings,

Safety instructions for operation

Note:
Other symbols/decals on the attachment refer
to special certification requirements for certain markets.
follow all instructions listed below may result
in electric shock, fire and/or serious injury.
• Save all warnings and instructions for future
reference. The term "power tool" in the warnings
refers to your mains-operated (corded) power tool or
battery-operated (cordless) power tool.
• Always use both hands to hold the product. Hold the
product at the side of your body.
• Use your right hand to control the throttle/power
trigger .
• Make sure that your hands and feet do not come
near the cutting attachment when the engine/motor
is running.
• When the engine/motor is switched off, keep your
hands and feet away from the cutting attachment
until it has stopped completely.
1472 - 002 - 11.11.2020