Operation; Power Supply - Laserworld RTI-Piko Série Mode D'emploi

Manual: RTI Piko Series

8. Operation

Please note that when the 'Emission LED' is on, the laser is enabled and may emit laser light.
There is one LED on the remote control pad, one on the rear side and one on the front side of
the device. The LED on the device flashes if the device is connectect to the power supply. The
LED on the control pad flashes if the device is switched on.

8.1 Power supply

Make sure that your device is provided with the correct voltage. Wrong voltage could lead to
irreparable damages. Please find the correct voltage data in the synoptical table at the end
of this manual. It must be ensured that the device is not directed to people or inflammable
objects during installation.
8.2 ILDA control
To control your device connect it via ILDA cables to an interface/controller. The pinout and
maximum voltages for the ILDA standard Sub-D connectors are:
Pin
1
2
4
5
6
7
8 (RTI Piko RGB 22)
9 (RTI Piko RGB 22)
13
14
15
17
18
19
20
21 (RTI Piko RGB 22)
22 (RTI Piko RGB 22)
25
page 7 / 33
Signal
X + (horizontal)
Y + (vertical)
Interlock A
Red +
Green +
Blue +
Light Red2+
Cyan+
Shutter
X – (horizontal)
Y – (vertical)
Interlock B
Red -
Green -
Blue -
Light Red2-
Cyan-
Ground
Voltage
+ 5.0 V
+ 5.0 V
-
+ 2.5 V
+ 2.5 V
+ 2.5 V
+ 2.5 V
+ 2.5 V
+ 5.0 V
- 5.0 V
- 5.0 V
-
- 2.5 V
- 2.5 V
- 2.5 V
- 2.5 V
-2.5 V
-