Laserworld RTI-Piko Série Mode D'emploi page 8

Manual: RTI Piko Series
Channels (RTI Piko RGB 22 / RTI Piko Rainbow Series):
Channel
1
2
3
4
5
3-Channel Adapter
In case you are using a controller with just three color outputs (RGB) you can use the provi-
ded D-Sub connector to wire both red together and blue and cyan together.
You just need to plug the connector into the ILDA OUT plug.
Important: If you are using this D-Sub connector you cannot use controllers with more
than three channels. Otherwise the controller hardware would pull down the intensity
of red and blue! If you have a controller with more than three channels you need to
patch the colors in the software and should not use this D-Sub connector.
After connecting select „LASER ON - ILDA IN" on the Remote Control Pad.
8.3 External Interlock
The Remote Control Pad has a built-in emergency stop. If there is the need for an external
interlock, please disconnect the Remote Control Pad and use the ‚Control' connection (RJ-48
connector) to connect it with an external interlock. Pins 7 and 8 are the emergency stop.
page 8 / 33
Colors / Wavelengths:
658nm
530nm
447nm
638nm
462nm