Scheppach HL810 Instructions D'origine page 25

17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails to
work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Malfunction
The hydraulic pump does
not start
The column does not
move down
Motor starts but column
does not move down
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
Possible cause
No electric power
Thermal switch of motor cut off
Low oil level
One of the levers not connected
Dirt in the rails
Wrong turning direction of 3-phase
motor
Remedy
Check cable for electric power
Engage thermal switch inside the motor casing again
Check oil level and refill
Check fixing of lever
Clean the column
Check turning direction of motor and change
GB | 25