Safety Recommendations - afx light Zoom Led Moving Head LEDWASH-1912Z Manuel D'utilisation

141-160
161-180
181-200
201-220
221-255
14 0-255
Thank you for choosing our AFX Light ZOOM LED MOVING HEAD. For your own safety, please read
this manual before installing the device. It contains important information about installation and use.
Keep this manual for further reference.
Our moving head wash has been built strictly in accordance with CE standards and complies with
international standards of the DMX512 protocol. It can either be single controlled or controlled in a
group with other units. It is suitable for large-scale performances, theaters, studios and large
discotheques.
The Moving head uses powerful, high quality LED lamps. Please handle the unit carefully and check
the contents of the carton if it is complete and hasn't suffered from transportation.

SAFETY RECOMMENDATIONS

The installer must be a qualified technician and follow the instructions contained in the manual

Keep the unit away from extreme temperatures, dust, water, rain and moisture.

Unplug the unit from the mains prior to opening the housing.

Do not open the housing if you are not a qualified technician as high voltages are present inside

the housing
Make sure that the mains voltage is the same as the rated input voltage of the unit.

Make sure that the unit is switched off before you connect it to the mains.

The manufacturer cannot be held responsible for damages resulting from the disrespect of the

instructions or unauthorized changes of the unit.
Make sure that the mains lead is not damaged. Regularly check the state of the mains lead.

Unplug the unit from the mains if it will not be used for a longer period of time.

This unit needs to be earthed.

Don't connect the unit to a dimmer pack.

Do not switch the unit on and off at short intervals.

At the first use the unit might emit a smell. This is normal and will disappear after a while.

Do not look directly into the light source. The strong light may damage your eyes and can cause

seizures to sensitive persons.
The moving head is used to create a decorative effect.

Don't start the unit when the ambient temperature changed drastically as condensation may

occur inside the housing. Wait until the machine has reached room temperature.
Don't carry the machine by the head but only by the handles.

Fasten the supplied safety cable at the provided hole on the bottom of the unit.

Don't operate the unit when it is not properly installed.

jump change (Self-propelled motor)
gradual change
Pulse change (Self-propelled motor)
sound control 1 (Self-propelled motor)
sound control 2 (Self-propelled motor)
Selective Color - jump change - gradual change - Pulse change
GB
6