EWT RUGGED3Y Manuel page 11

y of
SPECIFICATIONS
ng or
Model
EAN code
has
Power
Thermostat
Heat Settings
Fan Mode
sible
Handle
IP21 Protection
Overheat protection
on a
Anti-tilt protection
Voltage
Frequency
Product dimensions (WxDxH)
p pile
Produit weight
ugs,
away
ELECTRICAL CONNECTION
ace.
such
Only plug the appliance onto a 230-volt alternating current power supply (respect the indications on the identification
plate) and to an electrical installation which complies with the relevant standards. Please read the safety and installation
ings
instructions carefully prior to switching the appliance on.
rear
er to
INSTRUCTION FOR USE
Heat control – Switch Knob (See 2, Fig. 1)
eater
are
able
own,
n is
f fire,
other
Thermostat control knob (See 3, Fig. 1)
mum
tlet.
s to
in a
the
the
When the heat control is set to
Position
RUGGED3Y_A5.indd 11 RUGGED3Y_A5.indd 11
OFF
Cool Blow*
Half Heat
Full Heat
The heat output is controlled by the thermostat, according to the room temperature.
Turn the thermostat knob fully clockwise to maximum setting initially. When the room is warm
enough, reduce the setting slowly until the heater just clicks off.
The heater will now cycle on and off to maintain your selected room temperature.
An audible click may be heard when the thermostat operates - this is normal.
Note: If the heater does not come on when the thermostat is at a low setting, this is normally
because the room is warmer than the thermostat setting and is not a fault.
for cool blow, set the thermostat control (3) to maximum.
will turn the heater on and off to maintain a temperature of approximately 5°.
FR EN DE NL
RUGGED3Y
3 461 710 000 006
3000 W
Electromechanical
2 : 1500W / 3000W
Yes
Yes, 2 cold handles
Yes
Yes
Yes
230-240V~
50Hz
W24.6 x D16.2 x H24.8 cm
2.35 kg
PL SV
11
20/07/20//30 16:01 20/07/20//30 16:01