General Information; Reading And Keeping The Instructions For Use; Explanation Of Symbols; Safety - Gazzini 10039292 Mode D'emploi

Art. no. 10039297
1
Art. no. 10039298
1
Mirror housing with mirror arm Adapter ring for metric (outer
1 3
and integrated mirror clamp diam. 22 mm) handlebars
1 cheese head screw with Adapter ring for imperial (outer
2 4
hexagon socket head diam. 25.4 mm) handlebars
DIN 6912 M5 x 10 A2
2

| General information

2.1 | Reading and keeping the instructions for use

These instructions for use apply exclusively to the gazzini Bar-End Mirror shown above (for short:
mirror). They contain important information on installation, safety and the warranty. Read these
instructions carefully, in particular the safety instructions, before using the mirror. Failure to follow
the instructions can result in damage to the mirror itself or to your motorcycle, make it less safe
to ride on the road, and possibly cause consequential damage. Keep these instructions for future
reference. If you pass the mirror on to a third party, you must also hand over these instructions.
The instructions for use are based on the standards and regulations applicable in the European
12
2
4
3
2
3
4
Instructions for use (not shown)
5
Union and refl ect current state-of-the-art technology. If abroad, you should also observe any country-
specifi c guidelines and laws.

2.2 | Explanation of symbols

The following symbols and signal words are used in these instructions.
This symbol/signal word indicates a hazard with a medium risk level
WARNING!
which, if not avoided, may result in death or serious injury.
This symbol/signal word indicates a hazard with a low risk level which,
CAUTION!
if not avoided, may result in minor or moderate injury.
IMPORTANT! This signal word warns of possible material damage.
This symbol indicates useful additional information about assembly or
usage.
This symbol indicates that the packaging and product can be recycled.
3

| Safety

3.1 | Intended use

The gazzini Handlebar Mirror is intended as a replacement for a defective original mirror or to enhance
the look of your motorcycle. It comes with adapters for installing on many different motorcycles.
The mirror can be used externally at the ends of motorbike handlebars with an outer diameter of
22 mm (metric) or 25.4 mm (imperial) if suffi cient space is available. It can also be installed using
gazzini Bar Ends (sold separately), which are inserted or screwed into the handlebar, as long as the
handlebar meets the constructional requirements.
The mirror is E-approved and road-legal in member states of the European Union and states signed up
to the ECE regulations.
To ensure that you use the components correctly and safely on your motorcycle, always adhere to the
specifi cations in your vehicle owner's manual and the directions of the vehicle manufacturer.
The gazzini Mirror must only be used as described in these instructions. Any other use is considered
improper use and can result in material damage. The manufacturer and supplier accept no liability for
damage caused by improper or incorrect use.

3.2 | Safety instructions

WARNING!
Danger for children and persons with reduced physical, sensory or mental
abilities (e.g. partially disabled persons, elderly persons with reduced physical
and mental abilities) or lack of experience and knowledge (e.g. older children)!
• The product includes small parts and packaging which could be swallowed.
Keep these out of the reach of children, as there is a risk of asphyxiation if they
are swallowed.
13