What's Included; General Information; Reading And Keeping The Instructions For Use; Explanation Of Symbols - Gazzini 10040761 Mode D'emploi

BAR-END MIRRORS

1 | What's included

Art. no. 10040761 (angular)
Art. no. 10040762 (round)
1b
2
4
Countersunk screw with
Angular mirror housing
1a 3
hexagon socket head
Round mirror housing
1b ISO 10642 M6 x 60 A2
Mirror stem Clamping sleeve set
2 4

2 | General information

2.1 | Reading and keeping the instructions for use

These instructions for use apply exclusively to the aforementioned gazzini Bar-End Mirrors (for short:
mirrors). They contain important information on installation, safety and the warranty. Read these
instructions carefully, in particular the safety instructions, before using the mirror. Failure to follow
the instructions can result in damage to the mirror itself or to your motorcycle, make it less safe
to ride on the road, and possibly cause consequential damage. Keep these instructions for future
reference. If you pass the mirror on to a third party, you must also hand over these instructions.
The instructions for use are based on the standards and regulations applicable in the European
Union and refl ect current state-of-the-art technology. When abroad, you should also observe any
country-specifi c guidelines and laws.
10
5
1a
2
3
Cap screw with hexagon
5
socket head DIN 6912
M5 x 20 A2

2.2 | Explanation of symbols

The following symbols and signal words are used in these instructions.
This symbol/signal word indicates a hazard with a medium risk level
WARNING!
which, if not avoided, may result in death or serious injury.
This symbol/signal word indicates a hazard with a low risk level which,
CAUTION!
if not avoided, may result in minor or moderate injury.
IMPORTANT! This signal word warns of possible material damage.
This symbol indicates useful additional information about assembly or
usage.
This symbol indicates that the packaging and product can be recycled.

3 | Safety

3.1 | Intended use

The gazzini Bar-End Mirror is used as a replacement for a faulty original mirror or for enhancing the
look of the motorcycle. The mirror is designed for tubular motorcycle handlebars with an outside
diameter of 22 mm (metric) and an inner diameter of between 13.5 mm and 18 mm. The ends of the
handlebar must be open, i.e. they must not be blocked by thread inserts or similar.
The mirror is E-approved and road-legal in member states of the European Union and states signed
up to the ECE regulations.
To ensure that you use the components correctly and safely on your motorcycle, always adhere to
the specifi cations in your vehicle owner's manual and the directions of the vehicle manufacturer.
The gazzini Mirror must only be used as described in these instructions. Any other use is considered
improper use and can result in material damage. The manufacturer and supplier accept no liability
for damage caused by improper or incorrect use.

3.2 | Safety instructions

WARNING!
Danger for children and persons with reduced physical, sensory or mental
abilities (e.g. partially disabled persons, elderly persons with reduced physical
and mental abilities) or lack of experience and knowledge (e.g. older children)!
• The product includes small parts and packaging which could be swallowed.
Keep these out of the reach of children, as there is a risk of asphyxiation if they
are swallowed.
11