Responsibilities Of The Installer - American Standard 3052OD.0 Serie Instructions D'installation Et Manuel Du Propriétaire

OWNER'S MANUAL

RESPONSIBILITIES OF THE INSTALLER

The Installer must inspect and water test the product prior to installation to ensure the unit is free of defect
and /or damage. In the event of a problem, the unit must not be installed. If the packaging or product has
been damaged, please call immediately at 1-866-423-0800.
This product has been listed by INTERTEK / ETL and IAPMO / C UPC. The product has been tested and
complies with the following standards and guidelines: IAPMO /C UPC, UL-1795, ANSI Z-124.1.2,
ASME A 112.19.7, ASME A 112.19.15 & CSA B-45. The installer is responsible for compliance to
state and local codes.
This product is designed to be installed by a licensed tradesperson. Licensed plumbers and electricians
should be employed to insure proper installation. Installer assumes all liabilities for installation procedures.
Although American Standard has taken reasonable precautions to ensure that the Quick Drain is suitable for
® TM
residential plumbing; it is the responsibility of the installer to insure that the plumbing is acceptable for use of
the Quick Drain . American Standard® does not accept responsibility for damage arising from use of the
TM
Quick Drain .
TM
Only accessories authorized by manufacturer should be used with this product.
RESPONSIBILITIES OF THE INSTALLER
INSTRUCTIONS PERTAINING TO RISK OF FIRE,
ELECTRICAL SHOCK OR INJURY TO PERSONS
SAVE THESE INSTRUCTIONS!
WARNING! ALL INSTRUCTIONS LISTED IN THIS MANUAL SHOULD BE READ AND FOLLOWED CAREFULLY.
ALL PRECAUTIONS PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS MUST BE
UNDERSTOOD AND EXPLAINED TO OWNER.
TO REDUCE THE RISK OF INJURY, CHILDREN OR PERSONS WITH INFIRMITIES MUST NOT BE PERMITTED
TO USE THIS PRODUCT WITHOUT CLOSE AND CONTINUOUS SUPERVISION.
754818-100 Rev. A
5