Electrical Installation - American Standard 3052OD.0 Serie Instructions D'installation Et Manuel Du Propriétaire

Baignoire plain-pied

Masquer les pouces

Table des Matières

Les langues disponibles

All electrical wiring must be installed in accordance with the National Electrical Code and with all local codes.

All wiring shall be done by a qualified electrician. Run one, two or three branch circuits (as required) from the

main electrical service panel to the pump area of the framing structure to provide power to the unit.

Electrical components have specific wiring requirements. Refer to the matrix below for the electrical supply

requirements for the whirlpool bathtub and factory installed components.

Branch circuits must be rated for 110 – 120 volts. Use 12 Gauge, 3 conductor cable for the circuits. If the length

run exceeds 100 feet, check with local codes for requirements. Install moisture proof junction box(s) 6" above the

floor at the pump end of the framing for each circuit.

DO NOT INSTALL THE JUNCTION BOX(S) WHERE IT CAN BE REACHED WHILE SITTING OR STANDING

IN THE TUB OR TOUCHING THE FAUCETS.

QUICK DRAIN

, LIGHTS, WHIRLPOOL, AIR SPA, COMBO & HEATER ELECTRIAL REQUIREMENTS

This section lists the factory installed components of the Whirlpool and/or Air Spa Systems.

Note the required number of circuits and their rating for the Whirlpool & Air Spa unit you are

planning to install.

ELECTRICAL REQUIREMENTS FOR FACTORY INSTALLED COMPONENTS

Systems

Soaker w / Quick Drain

Soaker w / Light

Soaker w / Quick Drain

Whirlpool or Air Spa

Whirlpool or Air Spa w / Light

Whirlpool or Air Spa w/ Quick Drain

Whirlpool or Air Spa w/ Light & Quick Drain

Whirlpool & Air Spa (Combo)

Whirlpool & Air Spa (Combo) w/ Light

Whirlpool & Air Spa (Combo) w/ Quick Drain

Whirlpool & Air Spa (Combo) w/ Light & Quick Drain

Whirlpool Inline Heater - Dedicated Circuit

All electrical connections must be carried out by a certified electrician

754818-100 Rev. A