Table des Matières
Publicité
Retour sommaire
Comfort backrest pad "Laguna"
1.
2.
3.
E
F
16
A
B
C
You can equip the wheelchair with a slightly thinner
type of backrest pad; "Laguna". This pad allows
greater freedom of movement than the standard
backrest pad.
1. Start by removing the existing plastic backrest
(A) by loosening its 8 attachment screws (B) on
the inside of the plastic backrest.
2. Drill 8 holes according to the holes shown on the
new plastic backrest.
3. Fit the new plastic backrest (C) using 8 screws (D)
as shown in the diagram. Do not forget that the
spacers (E) must be placed between the plastic
backrest and the mounting plate (F) on each
D
backrest tube. Finally fi t the comfort backrest pad
into the plastic shell.
REA BELLIS
Publicité
Table des Matières
