Replacing The Blade; Ordering Replacement Parts; Storage; Disposal And Recycling - EINHELL RG-CM 36 Li Mode D'emploi D'origine

Anleitung_RG_CM_36_Li_SPK7:_
8.2 Servicing
Ensure that all mounting components (i.e.
screws, bolts, nuts etc.) are always tightened so
that the equipment can be safely operated at all
times.
Frequently check the grass catch assembly for
signs of wear.
Replace excessively worn or damaged parts
immediately.
In order to ensure that you enjoy your equipment
for many years to come, all screwed parts, as well
as the wheels and axles, should be cleaned and
lubricated.
There are no parts inside the equipment which
require additional maintenance.

8.3 Replacing the blade

The cutting components - i.e. the knife cage and
lower knife blade - are subjected to more wear and
tear than any other component of the unit. Therefore,
routinely check the condition of the blade and make
sure that it is tightly fastened. If the blade is
completely worn out, it must be immediately replaced
or ground sharp again. An excessively vibrating
mower means that the blade is not properly balanced
or has become deformed from striking an object. In
this case, the blade must be repaired or replaced.
For safety reasons, we recommend having the blade
replaced by an authorized professional. Important.
Wear work gloves! Only replace the blade with a
genuine Einhell replacement blade, as this will ensure
top performance and safety under all conditions.
Carry out the following steps to change the blade:
Undo the fastening screw (Figure 9/Item A).
Remove the blade and replace with a new one.
When fitting the blade (Figure 9/Item C), make
sure it is installed in the right direction. The
blade's air vanes must jut into the motor
compartment (see Fig. 9).
Now fit the metal plate (Figure 9/Item B) onto the
axle and insert the fastening screw.
Then retighten the fastening screw with the
universal wrench. The tightening torque should
be approx. 25 Nm.
15.12.2010 13:18 Uhr Seite 21

8.4 Ordering replacement parts

Please provide the following information on all orders
for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the equipment
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Spare blade Art. No.: 34.054.75
Replacement battery pack Art. No.: 45.114.30

9. Storage

Store the equipment and accessories out of children's
reach in a dark and dry place at above freezing
temperature. The ideal storage temperature is
between 5 and 30 °C. Store the electric tool in its
original packaging.

10. Disposal and recycling

The equipment is supplied in packaging to prevent it
from being damaged in transit. The raw materials in
this packaging can be reused or recycled. The
equipment and its accessories are made of various
types of material, such as metal and plastic. Defective
components must be disposed of as special waste.
Ask your dealer or your local council.
GB
21