Freezer Features; Door Storage - Maytag Performa Manuel Du Propriétaire

F
REEZER FEATURES
Shelves and baskets
(STYLE MAY VARY)
To remove shelves:
Remove shelf
from wall mount-
ing clips and pull
out of left side
mounting holes.
To reinstall shelves:
Reverse above procedure.
Baskets slide out for easy access of
items in back.
To remove baskets:
Pull basket forward to full extension.
Lift front handle to release basket from
rails and remove.
To reinstall baskets:
Reverse above procedure.
Chill shelf
(SELECT MODELS)
The Chill Shelf provides a space for
items to be chilled or frozen quickly.
To remove:
Lift chill shelf
from ice bin rails
and pull straight
out.
To reinstall:
Reverse above procedure.
IMPORTANT: The chill shelf should not
be installed if ice maker arm is in "off"
position.
WARNING
To avoid possible injury, including
death, do not place glass items in chill
shelf. Glass objects may shatter or
explode if exposed to extreme cold.
9

Door storage

ADJUSTABLE DOOR
BUCKETS
Door buckets adjust to meet individual
storage needs.
To remove buckets:
Lift the door bucket up until
it clears the retainers
on the door liner,
then pull the door
bucket straight out.
To reinstall buckets:
Slide bucket in above desired door
liner retainer and push down until
bucket stops.
Fixed door bucket
(SELECT MODELS)
The Fixed Door Bucket is
located in the upper sec-
tion of the freezer door.
IMPORTANT: Fixed door bucket is not
adjustable. If bucket is removed, freezer
light will not deactivate when door is closed.
Ice storage bin
(SELECT MODELS)
This Ice Storage Bin is located below the
automatic dispensing ice maker.
To remove:
Chill
Shelf Remove chill shelf.
Raise ice maker
arm to deactivate
ice maker.
Lift front of bin and
pull out to its full extension. Lift up
front of bin and remove.
To reinstall:
Slide bin into rails below ice maker
until bin locks into place. Drop ice
maker arm to activate ice maker, and
replace chill shelf.
IMPORTANT: Ice bin must be locked in
proper place for proper ice dispensing. If
freezer door does not close, bin is not in
proper location. Turn auger driver coun-
terclockwise
properly align ice
bin with back of
unit.
To avoid property damage, observe
the following:
Do not force ice maker arm down
or up.
Do not place or store anything in
ice storage bin.
Automatic ice maker
(SELECT MODELS)
This ice maker creates the ice used in the
dispensing system.
Using ice maker for the first time:
Confirm ice bin is in
place and
maker arm is down.
After freezer sec-
tion reaches between 0° to 2° F (-18°
to -17° C), ice maker fills with water
and begins operating.
Allow approximately 24 hours after
installation to receive first harvest of ice.
Discard ice created within first 12
hours of operation to verify system is
flushed of impurities.
Operating instructions:
Confirm ice bin is in place and ice
Ice Storage
maker arm is down.
Bin
After freezer section reaches between
0° to 2° F (-18° to -17° C), ice maker
fills with water and begins operating.
You will have a complete harvest of
ice approximately every 3 hours.
Stop ice production
by raising
maker arm until
click is heard.
Ice maker will remain in the off posi-
tion until arm is pushed down.
IMPORTANT: The chill shelf should not
be installed if ice maker arm is in "off"
position.
to
CAUTION
ice
ice