Clock; Tones; Fahrenheit And Celsius; Timer - Whirlpool GY395LXGB0 Guide D'utilisation Et D'entretien

On some models, if you do not want the clock time to be
displayed, press and hold the CLOCK pad (button) for 5 seconds.
When the clock is not displayed, you can see the time for 5
seconds by pressing the CLOCK pad (button).
To Set:
Before setting, make sure the oven, TIMER and COOK TIME
are off.
1. Press CLOCK.
2. Press the HR or MIN "up" or "down" arrow pads (buttons) to
set the time of day.
3. Press CLOCK or START.
Tones are audible signals that indicate whether a function has
been entered correctly, or when a cycle has ended.
To shut off all tones except the end-of-timer and error

tones:

1. Press and hold the STOP TIME button for 5 seconds.
2. A short tone will sound when the tones have been changed.
To turn tones back on, repeat step 1.
3. "OFF" will be displayed for 3 seconds when the tones have
been turned off, and "ON" will be displayed for 3 seconds
when the tones have been turned back on.
To choose between high and low volume tones:
1. Press and hold the DELAY button for 5 seconds.
2. A short tone will sound indicating the tones have been
changed.
3. Either "HI" or "Lo" will appear on the display for 3 seconds to
show the volume you have chosen.

Fahrenheit and Celsius

The temperature is preset at Fahrenheit, but can be changed to
Celsius.
To Change: Press and hold BROIL for 5 seconds. A tone will
sound and "°C" will appear on the lower oven display for 3
seconds. Repeat to change back to Fahrenheit.
When in Fahrenheit, "°F" follows the oven temperature.
When in Celsius, "°C" follows the oven temperature.
The Timer can be set in hours or minutes up to 12 hours and
59 minutes, and counts down the set time.
NOTE: The Timer does not start or stop the oven.
To Set:
1. Press TIMER SET.
If no action is taken after one minute, the display will return to
the time of day mode.
2. Press the HR or MIN "up" or "down" arrow pads (buttons) to
set the length of time.
3. Press START.
If not pressed within 5 seconds, the display will return to the
time of day mode and the programmed function will be
canceled.
When the set time ends, end-of-cycle tones will sound, then,
if on, reminder tones will sound every minute.
10

Clock

Tones

Timer

4. Press TIMER OFF anytime to cancel the Timer.
Remember, do not press the OFF pad (button) because the
oven will turn off.
To display the time of day when the timer is counting down, press
CLOCK.

Control Lock

The Control Lock shuts down the control panel pads (buttons) to
prevent unintended use of the oven(s).
When the control is locked, only the CLOCK, TIMER SET and
TIMER OFF pads (buttons) will function.
The Control Lock is preset unlocked, but can be locked.
To Lock/Unlock Control: Before locking, make sure the oven,
Timer and Timed Cooking (COOK TIME on some models) are off.
Press and hold START for 5 seconds, or until a single tone
sounds, "LOC" and a picture of a lock appear on the display.
Repeat to unlock and remove "LOC" from display.

Oven Temperature Control

IMPORTANT: Do not use a thermometer to measure oven
temperature because opening the oven door and element or
burner cycling may give incorrect readings.
The oven provides accurate temperatures; however, it may cook
faster or slower than your previous oven, so the temperature
calibration can be adjusted. It can be changed in Fahrenheit
or Celsius.
A minus sign means the oven will be cooler by the displayed
amount. No sign means the oven will be warmer by the displayed
amount. Use the following chart as a guide.
ADJUSTMENT °F
(ADJUSTMENT °C)
5° to 10°F (3° to 6°C)
15° to 20°F (9° to 12°C)
25° to 35°F (15° to 21°C)
-5° to -10°F (-3° to -6°C)
-15° to -20°F (-9° to -12°C)
-25° to -35°F (-15° to -21°C)
To Adjust Oven Temperature Calibration:
1. Press and hold BAKE for 5 seconds until the oven display
shows the current calibration, for example "0° CAL."
2. Press the TEMP "up" or "down" arrow pads (buttons) to
increase or to decrease the temperature in 10°F (6°C)
amounts. The adjustment can be set between 30°F (18°C)
and -30°F (-18°C).
3. Press START.
To Display Temperatures in °C instead of °F:
Press and hold the BROIL button for 5 seconds. A short tone will
sound, and the temperature display will switch to °C. Repeat to
switch back to °F.
COOKS FOOD
...a little more
...moderately more
...much more
...a little less
...moderately less
...much less