Publicité
Les langues disponibles
Les langues disponibles
DVD
▲
▼
/
number
keys
(0 to 9)
DISPLAY
Playing DVD/Video CD
Caution
• Not all functions will operate for every DVD. See the individual
DVD's instructions for details on the features supported.
• Fingerprints on a disc may adversely affect playback. If a
problem occurs, remove the disc and check for fingerprints on
the playback side. Clean the disc if necessary.
• When using the remote control, be careful to press one button
at time. Pressing multiple buttons at the same time may cause
erroneous operation.
• If you switch the power or ignition key OFF during playback,
playback will continue where you left off when you resume
playback.
• If you try to perform an invalid operation (based on the type
of disc being played), the following mark is displayed on the
monitor screen:
• If a PAL type disc is inserted, the message "VIDEO SIGNAL
SYSTEM IS NOT CORRECT" is displayed, and playback is not
available.
Insert a disc with the label side facing up.
To load discs, see "Loading and Unloading Discs" on page 9.
Playback starts.
• The reverse side of a double-sided DVD will not be played
automatically. Remove the disc, turn it over, and reinsert it.
• It may take some time before playback starts after loading a disc.
10
-EN
DVE-5207.indb 10
If a menu screen appears
On DVDs and video CDs with playback control (PBC), menu screens
may appear automatically. If this happens, perform the operation
described below to start playback.
• For many discs, the menu screen can also be displayed by pressing
MENU.
ENT.
DVD menu
Press
,
,
▲
▼
press ENT.
■
• For some discs it is possible to select items directly from the menu
screen using the number keys ("0" to "9").
MENU
Video CD menu
RETURN
Use the number keys ("0" to "9") to select the desired
number, then press ENT.
REPEAT
• The menu screen does not appear when the PBC function is
turned off. In this case, set VCD PLAY MODE to turn on the PBC
function. For details, Refer to "Setting the Video CD Play Mode"
(page 19).
Stopping Playback (PRE-STOP)
Press ■ during playback to stop playback. That position is stored in
memory.
1
Press
■
"PRE-STOP" is displayed.
2
Press
Playback starts from the position at which it was stopped.
• For some discs, the position at which playback was stopped may
not be accurate.
Stopping Playback
Press
twice during playback.
■
"STOP" is displayed, and playback stops.
• Playback stops also when ■ is pressed for more than 2 seconds.
• Playback starts from the beginning when
playback is stopped.
Fast-forwarding/Fast-reversing
1
During playback, press and hold
or
When pressed for more than 1 second, the disc is
forwarded/reversed at double speed.
When held in 5 more seconds, the disc is forwarded/
reversed at 8 times the normal speed.
2
Release
• No sound appears during fast-forward/fast-reverse.
• Fast-forwarding/fast-reversing of only a track being played back
can be made on the Video CD equipped with PBC (playback
control).
• For DVDs and video CDs with playback control (PBC), the menu
screen may reappear during fast-forwarding/fast-reversing.
or
to select the desired item, then
during playback.
in the PRE-STOP mode.
/
/
is pressed while
(fast-forward).
or
to return to normal playback.
(fast-reverse)
4/14/05 5:33:53 PM
Publicité
