Unpack The Refrigerator; Reverse Door Swing (Optional) - KitchenAid KBCA06XPBL01 Guide D'utilisation Et D'entretien

Unpack the Refrigerator

WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces before turning
on the refrigerator. Rub a small amount of liquid dish soap
over the adhesive with your fingers. Wipe with warm water
and dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your refrigerator. For
more information, see "Refrigerator Safety."
Properly dispose of packaging.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator
for cleaning or service, be sure to protect the floor.
Always pull the refrigerator straight out when moving it.
Do not wiggle or "walk" the refrigerator when trying to move
it, as floor damage could occur.
Clean Before Using
After you remove all of the packaging materials, clean the inside
of your refrigerator before using it. See the cleaning instructions
in "Refrigerator Care."
Important information to know about glass shelves
and covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature changes or impact, such as bumping.
For your protection, tempered glass is designed to shatter
into many small, pebble-size pieces. This is normal. Glass
shelves and covers are heavy. Use special care when
removing them to avoid impact from dropping.

Reverse Door Swing (optional)

1. Unplug refrigerator or disconnect power.
2. Remove three screw plugs (at top and bottom of refrigerator)
from the new hinge locations on the refrigerator cabinet. Do
not discard the screw plugs.
A
A. Screw plugs
3. With a ⁷⁄₆₄" Allen wrench, remove the top hinge pin and set
aside.
4. Tilt the door forward and lift it off the bottom hinge pin. Set
the door aside.
5. Remove the three hinge screws from the top hinge and
remove the hinge.
A
B
A
A. Hinge screws
B. Hinge pin hole
6. Reinsert the hinge pin into the hinge pin hole and turn the
hinge upside down so that the hinge pin points up.
7. Install the hinge on the bottom opposite side of the
refrigerator using the three hinge screws.
5