Publicité
Les langues disponibles
Les langues disponibles
F R O N T P A N E L
1
2
3
(1)
POWER SWITCH
This two-way toggle switch applies mains power to the unit. The red POWER STATUS LAMP (3) will
illuminate when this switch is in the ON position.
(2)
STANDBY SWITCH
This two-way toggle switch allows the amp to be placed in STANDBY mode. In the STANDBY position
the tubes stay hot but the amplifier is not operational. Switching to the ON position places the amp in
active mode.
(3)
POWER STATUS LAMP
This indicator illuminates when mains power is being supplied to the amp.
(4)
PRESENCE
Used to fine-tune the high frequency range of the speaker enclosure by varying the damping factor of
the amplifier at high frequencies.
(5)
RESONANCE
Used to fine-tune the low frequency range of the speaker enclosure by varying the damping factor of
the amplifier at low frequencies.
(6)
MASTER VOLUME
This control sets the overall volume level of the amp. Once the desired balance between the three
channels in the amplifier has been achieved, the entire output level of the unit can be increased or
decreased by rotating this control. Clockwise rotation increases level; counterclockwise rotation
decreases level.
(7)
TREBLE
This control, on both the Ultra and Crunch channels, varies the high frequency response of the
amplifier. It is an active control (shelving type) and allows ˜ 12 dB of boost or cut.
(8)
MID
This control, on both the Ultra and Crunch channels, varies the mid frequency response of the amplifier.
It is an active control (peak/notch type) and allows ˜ 12 dB of boost or cut.
4
5
6
7
8
13
9
10
11
15
12
5
14
20
16
17
10
18
19
Publicité
