Publicité
Les langues disponibles
Les langues disponibles
8. MAIN PROGRAMMABLE FUNCTIONS
It is possible to set some alarm functions to adapt the alarm system to the motorcycle and
its driver's needs. All possible set-up are described in the table below where in bold are hi-
ghlighted the factory set-up.
FUNCTION
Passive arming
Passive arming type
Horn alarm output
Buzzer Arm./Dis.
Direction indicators
Arm./Dis.
Alarm line
(Yellow/Green wire)
Alarm line
(Purple wire)
Remote control
buttons
Panic alarm
Override Code length
Type of low
consumption mode
Activation timing of
low consumption
mode
Use only the PRG007 PROGRAMMER V3 to select the various functions of the product. Sof-
tware updates for the PRG007 PROGRAMMER V3 and information about the programmable
functions are available ONLINE in the TECH AREA/VEHICLES AREA of the www.metasystem.it
website.
9. PAIRING THE RADIO REMOTE CONTROLS (MAX 8)
Once you have made the electrical connections to the alarm, connect the vehicle battery, check
that the vehicle instrument panel is off and connect the DEFCOM 3.1B control unit.
Activate the instrument panel and immediately deactivate it, after few seconds the central unit
will emit 2 Beep and 2 Boop to confirm that it's possible pair the remote controls and the LED
will flash very fast.
Within 60 seconds press simultaneously the 2 buttons on the first radio remote control; one
BEEP sound and the LED turns OFF for 2 seconds to confirms pairing.
Repeat the operation for all of the other radio remote controls to be paired, each time checking
that they have been stored successfully.
To complete the storing phase, wait for 1 minute, or activate the instrument panel and the cen-
tral unit will emit 2 Beep and 2 Boop and the LED turns OFF.
In case of the time to pair the remote controls is over the central unit automatically
comes out from the pairing phase (more than 1 minute from the last remote paired)
will emit 2 Beep and 2 Boop and the LED turns OFF; to adds some other remote con-
trols proceed as described in the paragraph "15. ADDITIONAL REMOTE CONTROLS" of
the user manual.
DEFCOM 3.1B Installation Manual
OPTION "A"
Enabled
Only immobilizer
Continuous
Enabled
Enabled
Active if removed the
earth connection
Active if removed
the earth connection
Button "A":
Arming/Disarming
Enabled
Only first 3 digits
Stop Mode
5 days
OPTION "B"
Disabled
Immobilizer and
switches alarm
Alternated
Disabled
Disabled
Active with
earth connection
Active with
earth connection
Button "A": Arming
Button "B": Disarming
Disabled
5 digits
Deep Sleep Mode
10 days
OPTION "C"
Immobilizer,
switches alarm
and tilt sensor
Arm./Dis. switch
input using CARD
11
Publicité
