Power Fist 8904807 Manuel De L'utilisateur page 8

8904807
5. Do not allow people, mobile equipment or vehicles to pass over
unprotected power cords.
a. Position power cords away from traffic areas.
b. Place cords in reinforced conduits or place planks on either side of
the power cord to create a protective trench.
UNPACKING
WARNING! Do not operate the tool if any part is missing. Replace the
3missing part before operating. Failure to do so could result in a
malfunction and personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
IDENTIFICATION KEY
A Mobility Handle
B Splitting Wedge
C Carriage
D Ram
E Safety Clutch Handle
F Ram Release Handle
ASSEMBLY & INSTALLATION
Dashed numbers in parenthesis (Fig. 1-1) refer to a specific point in an
illustration or image.
Have a second person help you assemble the tool.
1. Remove the log splitter from the packaging and place it on a flat, level floor.
8
22 Ton Electric Kinetic Log Splitter
G ON/OFF Switch
H Power Cord
I Belt & Flywheel
Cover (2)
J Rear Bracket
K Wheel (2)
For technical questions call 1-800-665-8685
L Front Bracket
M Motor
N Drive Belt
O Ram Return Sprng
P Flywheel (2)
V4.0
Fig. 1