Power Fist 8904807 Manuel De L'utilisateur page 11

V4.0
4. Keep the tool handles clean, dry and free from oil/grease at all times.
5. Do not use compressed air near the bearings when cleaning the log splitter.
6. Maintain the tool's labels and name plates. These carry important information.
If unreadable or missing, contact Princess Auto Ltd. for replacements.
WARNING! Only qualified service personnel should repair the tool. An
improperly repaired tool may present a hazard to the user and/or others.
LUBRICATION
NOTICE! NEVER use a penetrating oil to lubricate the tool. Penetrating oil
may act as a solvent that can break down the grease and cause the tool
to seize up.
1. Lubricate the surface of the beam, the meshing parts of the gear shaft
(#2) and rack (#33) with light machine oil weekly or every 30 hours.
2. Use a little oil to prevent rust on other metal parts.
DRIVE BELT ADJUSTMENT/REPLACEMENT
Numbered references in parenthesis (#1) refer to the included Parts List.
1. Unplug the log splitter.
2. Remove the left and right Belt Covers (#50 and
#51) by loosening two 10 mm bolts (#76) and
six Phillips head bolts (#77) per cover.
3. Remove the Safety Clutch and Ram Release
Handles.
4. Loosen the four 13 mm Hex Nuts (#81, Fig. 6) and
then slide the motor towards the Flywheel (#3).
5. Remove the Drive Belt (#60) from the Motor
Pulley (#59) and the Flywheel.
6. Replace the Drive Belt.
7. Tension the Drive Belt by sliding the motor
away from the Flywheel. Adjust the Drive Belt
until there is 3/8 in. deflection (Fig. 7-1).
8. Tighten the four 13 mm Hex Nuts (#81) securing the motor.
9. Reinstall the safety clutch and ram release handles, then replace the left
and right Belt Covers.
Visit www.princessauto.com for more information
22 Ton Electric Kinetic Log Splitter 8904807
Fig. 6
Fig. 7
11