Publicité
Les langues disponibles
Les langues disponibles
8904807
STORAGE
Do not store the log splitter outside. Exposure to rain and ice can damage it.
Keep the log splitter in a cool, dry place that is out of direct sunlight.
REMOVAL FROM STORAGE
Lubricate the log splitter as described in the Lubrication section and then
perform all tasks in Operation Before Each Use section.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Problem(s)
Log splitter will
not start.
Log does not
split.
Ram retracts
slowly or not at
all.
Drive belt noise
during start up or
while splitting.
12
22 Ton Electric Kinetic Log Splitter
Possible Cause(s)
1. Power cord is not plugged in.
2. Fuse or circuit tripped.
3. Damaged power cord.
4. Burned or failed power switch.
1. Log positioned incorrectly on
carriage.
2. Log exceeds maximum
allowable size.
3. Large knot in log.
1. Debris in the rack system.
2. Damaged or worn return
spring.
1. Loose drive belt.
2. Worn drive belt.
3. Drive belt is wet from outdoor
use.
Suggested Solution(s)
1. Plug in saw to power source.
2. Replace fuse or reset breaker.
3. Contact Technical Support.
4. Contact Technical Support.
1. Re-position log on carriage
against wedge.
2. Maximum allowable log size is
20 x 21 in.
3. Repeat splitting function with
log in place.
1. Clean and lube the rack system
periodically.
2. Inspect return spring and
replace if needed.
1. Tighten drive belt.
2. Replace drive belt.
3. Dry and clean drive belt.
For technical questions call 1-800-665-8685
V4.0
Publicité
