Power Fist 8904807 Manuel De L'utilisateur page 10

8904807
1. Plug the log splitter into an appropriate power source.
2. Turn on the unit and allow the motor to reach full speed.
3. Load a log onto the Carriage and
place it against the Splitting Wedge.
Do not load a log against the Ram.
4. Always split the log against the grain
(Fig. 3). Do not attempt to split
against the grain (fig. 4)
5. For safety, splitting a log is a two-
handed operation. Place one hand on
the Safety Clutch Handle (Fig. 5-1)
and one hand on the Ram Release
Handle (Fig. 5-2).
6. Push the Clutch Handle toward the
log and then hold it in position.
7. Push the Ram Release Handle
forward towards the log. The Ram
will release and push the log
through the Splitting Wedge.
8. Release both handles. The Ram will
retract and reload for the next
splitting operation.
9. If the log is partially split (knot) or stuck
on the Splitting Wedge, then repeat the
steps above You may need to reorient
the log on the carriage.
CARE & MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier
to control and will have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3. Follow instructions for lubricating and changing accessories.
10
22 Ton Electric Kinetic Log Splitter
For technical questions call 1-800-665-8685
V4.0
Fig. 3
Fig. 4
Fig. 5