Publicité
Les langues disponibles
Les langues disponibles
• When you press the memory button M again, the last individual measurement
is displayed (in this example, measurement 03).
• When the memory button M is pressed again, you can view your individual measured values.
• To switch the device off again, press the Start/stop button
You can exit the menu at any time by pressing the Start/stop button
• In order to delete all saved measurements from a user, first select it as described.
• A A flashes on the display and the average value of all saved measured values in this user memory is
displayed.
• Press and hold both setting buttons + and - at the same time for approx. 5 seconds.
• C C L 00
L 00 appears on the display. All the values in the current user memory are
deleted. The device then switches off automatically.
8. Cleaning and maintenance
• Clean the device and cuff carefully using a slightly damp cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under water, as this can cause liquid to enter and dam-
age the device and cuff.
• If you store the device and cuff, do not place heavy objects on the device and cuff. Remove the batteries.
9. What if there are problems?
Error
Possible cause
message
Unable to record a pulse.
Er1
You moved or spoke during the
Er2
measurement.
The cuff is not attached correctly.
Er3
The measured values are outside
Er4
the specified measurement range.
An error occurred during the mea-
surement.
or wait 30 sec.
Solution
Please wait one minute and repeat the measurement.
Ensure that you do not speak or move during the mea-
surement.
Please observe the information in chapter „Attaching the
cuff" and take another measurement after one minute.
Please wait one minute and repeat the measurement.
Ensure that you do not speak or move during the mea-
surement.
If the error occurs repeatedly, consult a doctor to check
you are healthy.
30
.
Publicité
