Password Management; Sw164Osm Standard Matrix Programming; Sw164Osm Osm Matrix Programming; Specifications - Videotec KEYPLUS Manuel D'instructions

Password management

Problem
The operator wants to prevent unauthorized
personnel from having access to the keyboard.
The passwords of the keyboards are different,
even if they are all connected to the same matrix.
The passwords of a
forgotten or lost.
The operator wants to disable a password.

SW164OSM Standard matrix programming

Problem
The preset sequence cycles do not work as
expected.
The time/date parameters have been set
correctly but the matrix always shows the night
sequence.
SW164OSM matrix programming
Alarms
Problem
After having configured the alarms, the matrix
exits from the programming mode and gives
immediately an alarm signal even if no alarm
contact has been activated.
Closing a contact, the relevant alarm does not
activate.
The alarm ceases automatically without the
intervention of the operator.
Other options
Problem
The text on the menu output is considerably
shifted upwards.

Specifications

190 x 55 x 185 mm
Dimensions:
980 g
Weight:
keyboard have been
Possible cause
Wrong
time/date
matrix is showing the night
sequence.
Some days of the week have
been defined as holidays
during the matrix setup by
means
Computer.
Possible cause
During the setup phase, the
connection password
been disabled.
The passwords are "local"
and stored into
keyboard.
-
-
setting of
parameters:
of Personal
Possible cause
During the matrix setup,
some alarm contacts have
been defined as Normally
Closed.
The contact has
defined as Not Used
The time reset has been
activated or the alarm
signals have been defined
as "Continuous signals"
Possible cause
The NTSC video system has
been set.

Power supply specifications

Input voltage:
Output voltages:
Connector:
pin 1-3: 9V
pin 2-4: 14V
Page 23
Remedy
During the setup phase, set the
has connection password to a different
value from 000000.
Set (if necessary)
the passwords for all keyboards.
Please contact the supplier
Set it to 000000. Note: for safety
reasons, we recommend setting at
least the setup password.
Remedy
the Check if the set time and the
the start/end of the day sequence have
been set correctly.
Redefine all days of the week as
working days during the setup by
means of PC; for further information
please contact the supplier.
Remedy
Close the contact
contact by means of the alarm
common wire) or define it as
Normally Open.
been Activate the contact as Normally
Open or Closed
Set the correct reset options.
Remedy
In the menu 4. System parameters
set the PAL video system.
230V~ 50Hz 30VA
9V~ 50HZ 8VA
14V~ 50HZ 8VA
Mini Din 4 poli
~
~
the same
(short the
KEYPLUS9702