Kärcher K 2.36 M Mode D'emploi page 11

Cleaning operations which produce oily
waste water, e.g. engine washes, underbody
washes, may only be carried out using wash-
ing stations equipped with an oil separator.
This appliance was designed to be used with
detergents which are supplied or recom-
mended by the manufacturer. The use of
other detergents or chemicals may compro-
mise the safety of the appliance.
Safety Devices
Caution
Safety devices protect the user and must not be
modified or bypassed.
Power switch
The appliance switch prevents unintentional op-
eration of the appliance.
Lock trigger gun
This lock locks the lever of the trigger gun and
prevents the inadvertent start of the appliance.
Operation
Description of the Appliance
When unpacking the product, make sure that no
accessories are missing and that none of the
package contents have been damaged. If you
detect any transport damages please contact
your dealer.
Illustrations on Page 2
1 High pressure connection
2 Detergent suction hose (with filter)
3 Appliance switch "0/OFF"/ „I/ON"
4 Storage for high-pressure hose
5 Carrying handle
6 Storage for spray lance
7 Storage for trigger gun
8 Mains cable with mains plug
9 Water connection
10 Bearing wheel
11 Coupling element for water connection
12 Trigger gun
13 Lock trigger gun
14 High pressure hose
15 Clamp for high pressure hose
16 Spray lance with high pressure nozzle
17 Spray lance with dirt blaster
Special accessories
Special accessories expand the possibilities of
using your appliance. Please contact your
Kärcher dealer for further information.
Before Startup
Mount loose parts delivered with appliance prior
to start-up.
Illustrations on Page 2
Illustration
Pull out the clamp for the high-pressure hose
from the trigger gun (e.g. a small screwdriv-
er).
Illustration
Connect high pressure hose to trigger gun.
Push the clamp in until it locks. Check the se-
cure connection by pulling on the high-pres-
sure hose.
Water supply
According to the applicable regula-
tions, the appliance must never be
used on the drinking water supply with-
out a system separator. Use a suitable
system separator manufactured by Kärcher; or,
as an alternative, a system separator as per EN
12729 Type BA.
Note: Impurities in the water can damage the
high-pressure pump and accessories. For pro-
tection, the use of the Kärcher water filter (op-
tional accessory, order no. 4.730-059) is
recommended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Screw the coupling unit (supplied) to the wa-
ter connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
11
English