Sovelor MAGNUM 140 Manuel D'utilisation Et De Maintenance page 13

maximum operating temperature. To reset the
en
heater, eliminate the cause of the block (if necessary,
contact the support centre), remove the cover (PIC.
it
de
es
reset the burner, eliminate the cause of the block (if
fr
necessary, contact the support centre), remove the
nl
pt
da
block (if necessary, contact the support centre) and
switch the heater on again.
no
sv
pl IMPORTANT: THE
(ALREADY SET UP BY THE MANUFACTURER), IF
ru IT IS NOT RE-SET UP, DOES NOT COMPROMISE
THE CORRECT OPERATION OF THE HEATER.
cs
and shutdown of the ventilation in the preheating and
hu
post-ventilation stages of the heater.
Depending on the room temperature (very cold weather
sl
or very hot weather, SEE TAB. "CONFIGURING THE
ELECTRONIC REGULATOR"), it may be required to
tr
change the reference parameter.
hr
the power plug is connected to the power mains.
lt
-Press the "SET" key.
lv
-Press the "SET" key to access.
et
ro
IMPORTANT: THE
sk
DOES NOT HAVE THE ROOM THERMOSTAT
FUNCTION.
bg
uk
11. CLEANING THE FILTERS
bs
MODEL:
(PIC. 11)
el
quality of the fuel used:
zh
you preserve the gaskets.
you do not damage it.
reassemble the gaskets correctly.
ELECTRONIC REGULATOR
ELECTRONIC REGULATOR
See the preventive maintenance schedule.
12. STORAGE AND TRANSPORT
WARNING: BEFORE ANY MOVEMENT, STOP THE
HEATER (SEE PAR. "TURNING OFF THE HEATER"),
DISCONNECT THE POWER SUPPLY BY REMOVING
AND WAIT FOR THE HEATER TO COOL DOWN
COMPLETELY. KEEP THE HEATER IN A LEVEL
POSITION WHEN MOVING IT.
In order to keep the heater in the best possible
conditions, we recommend following the procedure
below (follow all safety-related instructions):
It can be lifted with the forklift truck, by using
suitable chains and suspension hooks (the heater is
equipped with eyebolts).
possible, we recommend placing it in a dry place
away from potential external damage.
In models with a room thermostat connection, remove
the plug connected to the heater and connect the room
(PIC. 15)
IMPORTANT: ONLY USE ORIGINAL KITS TO DIRECT
APPLICABLE).
In order to avoid heater operating problems or harm
to people, pay attention to the layout of the air ducting
positioning the ducting pipes reducing the number of
meters must be without curves.