Create Pdf Report; Delete Data - VOLTCRAFT 1435090 DL-200T Mode D'emploi

14. CREATE PDF REPORT

• Connect the data logger to your computer.
• A PDF report is produced automatically. Red LED control light (2) is on
and "USB PDF" is shown in the LC display. Do not disconnect the data
logger from your computer during this period.
• Open the data logger drive on your computer.
• Once the PDF file has been generated successfully, "PDF" disappears
from the LC display (5). "USB" remains on the LC-display.
• Select and open the PDF file.
• The PDF report contains general device information, data logger
settings, alarm statuses and a graph showing the measured values
during the recorded time.
• Save the PDF file on your computer and close the file.
• Disconnect the data logger from your computer.
Depending on the number of stored measurements, generating the
PDF file may take up to approximately 30 seconds.
Only the maximum and minimum measurements during recording
will be shown in the PDF report but not during the pause function.

15. DELETE DATA

Generate and save the PDF report before deleting measured data,
if needed.
Deleting data does not affect the configuration settings.
• Press and hold buttons DOWN and ENTER and connect the data logger
to your computer. "USB" is shown in the LC display. All data is deleted.
• Release the buttons.
• The data logger driver on your computer is empty, that means all data
was successfully deleted. Disconnect data logger from your computer.
90