Publicité
Les langues disponibles
Les langues disponibles
Setting the units of weight
Note: The standard unit of weight is kilogram (kg).
The factory default setting for the scales as supplied
is "kg".
P ress the kg / lb switch to select the unit of weight.
The units will be displayed in the LC display as
follows:
Kilogram (kg): see Figure B
Pound (lb):
see Figure F
Switching on your scales /
measuring your weight
Tip: Weigh yourself at the same time of day
(preferably in the morning) after visiting the toilet,
with an empty stomach and without clothing to
ensure that your results are compatible.
P lace the scales down on a solid, flat horizontal
surface.
S tep on to the scales.
P lace even weight on each leg.
I f at all possible stand on the same areas of the
platform each time and do not move. Moving
during the weighing process can lead to
discrepancies in the results.
The scales will start to measure immediately.
After blinking 3 times, the weight display will
display the result, as shown in, for example,
Fig. C.
Note: If the scale shows „C" after you step off
the platform
(see Fig. G), there has been
2
an error weighing. Repeat the process.
Note: If the scales show "OL" (see Fig. E), it
signals that the scales are overloaded. Observe
the maximum capacity of 180 kg (396 lb).
S tep off the platform. The scales switch off
automatically after about 10 seconds. Until
then the weight measurement remains visible.
Note: After a change of location and follow-
ing every battery change, the scales must be
re-calibrated. To do this, proceed as follows:
8
GB/IE
102611_silv_Personenwaage_content_GB_IE_FI_SE_DK_BE_NL.indd 8
S tep onto the scales. The scales will show you
an incorrect measuring result. Step off the plat-
form. The scales will calibrate automatically.
W ait until the scales switch off automatically.
S tep onto the scales once again. The scales
will show you the correct measuring result.
Troubleshooting
T his appliance has delicate electronic compo-
nents. This means that if it is placed near an
object that transmits radio signals, it could
cause interference. If the display indicates a
problem, move such objects away from it.
E lectrostatic charge can lead to the appliance
failing. In cases of the appliance failing to work
remove the batteries for a short while and then
replace them.
Cleaning
D o not use chemical cleaners or scouring
agents for cleaning the device.
C lean the device using a slightly moist cloth.
For more stubborn dirt you can also apply a
weak soap solution to the cloth.
N ever immerse the device in water or other
liquids. Ignoring this advice may damage the
device.
E nsure that no water enters the device. If this
does occur, then wait until the device has dried
out fully before you use it again.
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
28.10.14 11:36
Publicité
