Publicité
Les langues disponibles
Les langues disponibles
Duct Connection
Floor
1. Attach rubber gasket around edge of transition piece.
• Flat side of rubber gasket must be on under side of
transition piece. See figure below.
A
B
A—Transition piece
B—Gasket
Floor Connection
2. Place round end of transition piece into floor. Secure
transition piece using 8 screws provided in kit.
• Lift edge of rubber gasket to install screws.
• Make sure round edge of gasket is facing up.
3. Insert floor plate into elbow duct and attach using 2
screws provided.
• Tighten only front screw.
• When installed, wide flange of floor plate must face
toward back of range.
A
E
A—Blower
B—Floor elbow duct
C—Floor plate
D—Transition piece and gasket
E—Blower transition
Insert Floor Plate into Elbow Duct and Attach
4. Remove blower transition from blower.
5. Attach floor elbow duct to blower using 2 screws
6. Connect electrical supply.
7. Push range into position.
Backwall
1. Remove screw in front of blower transition separating
2. Place hose clamp around round end of blower
B
3. Place long end of thimble into wall and secure
C
4. Place hose clamp provided around short end of
D
5. Connect electrical supply.
6. Carefully push range back into position. Avoid
12
provided.
• Floor elbow duct should be inside blower.
• Tilt range slightly while pushing in range. Tilting
range allows floor plate to clear gasket.
• Make sure that floor elbow duct is directly over
transition piece and rubber gasket.
• Rubber gasket provides a seal between floor elbow
and transition piece.
blower transition from blower housing.
transition and attach flex duct to blower transition
using hose clamp.
A
D
A—Blower and transition piece
B—Hose clamps
C—Flex duct
D—Thimble
Backwall Connection
thimble using four screws provided, one in each
corner.
thimble. Attach opposite end of flex duct to short
end of thimble using hose clamp.
pinching transition piece or flex duct.
B
C
Publicité
