How Do Ilight The Fire In My Aduro H2 - ADURO H2 Mode D'emploi

NOTE. The burning cave must not be removed during use with either wood nor pellets. Never use
wood with nails and other objects that can damage the screw conveyor carrying the pellets.
3.2.2 Pellets
You can only use Ø6-8 mm pellets with
a maximum length of 40 mm – type
ENplus quality A1. We recommend that
you use quality pellets. Ask your Aduro
dealer. The quality of the wooden pellets
has a direct influence on the noise level
of the stove, the efficiency and the
cleaning interval.
3.2.3 How do I add pellets?
The enclosed funnel is placed in the
opening of the pellet box and the pellets
are added. The pellets are distributed
with a poker in the box to make use of
the entire capacity (approx. 15 kg of
pellets).
First use only (or if the snail pipe due to
another reason is emptied of pellets)
Snails must be filled with pellets:
Open the door to the combustion chamber and lift the front of the "burn cave" (the black cast iron cone with
the Aduro logo) so you can see the pellets. Close the stove's door. Press and hold the RESET/ALARM
button and the snails will start transporting the pellets. (Only at OFF mode yellow lamp). After about 12
minutes where you hold the RESET/ALARM button, the snail pipe will be filled with pellets. Stop pressing
the RESET/ALARM button when the pellets are about 2 cm under the snail pipe's top edge. Put in the "burn
cave" and close the stove's door.
Under point 8 you'll find an overview of control and different alarms.
Burning cave
3.3 How do I light the fire in my Aduro H2?
You can light the fire using just pellets or light it manually with wood – or a combination where you put
firewood in the combustion chamber and use the pellets to light the fire.
Aduro H2 has a damper (see illustration below) where you manually can switch off the air supply to the pellet
combustion. When this damper is closed, the pellet function won't work. This damper is mounted since you
have to shut off air supply to the pellet function in order to obtain the most optimal combustion of wood
pieces. If you use an Aduro H2 with wood and pellets, the damper has to be open (pulled forwards).
NOTE: The first time you light the fire in the hybrid stove, you should use normal firewood because the door
has to stand slightly ajar. This should be done to prevent the gasket from sticking to the paint on the stove.
48