Publicité
Les langues disponibles
Les langues disponibles
Gravity spray attachment
Read the operating instructions carefully before using the tool and observe the
safety instructions. Keep the operating instructions in a safe place.
The Gravity Feed spray attachment was developed for applying water-soluble paints
and lacquers as well as paints and lacquers containing solvents. It is also suitable for
processing spray film. Wall paints (dispersion and latex paints) cannot be processed.
•
CAUTION!
The units may only be used with a functional valve. If paints rises in
the ventilating hose (Fig. 1 , item 7) do not operate the unit further!
Dismantle and clean the ventilating hose, valve and diaphragm and replace
the diaphragm if necessary.
•
Do not place the spray gun on the side.
•
Do not combine components from different spray attachments.
The parts could be damaged.
1) Union nut
3) Nozzle
5) Stand (fold-out)
7) Ventilating hose with valve
9) O-ring
11) Trigger
13) Container seal
Preparation of the Coating Material
The Standard spray attachment can be used to spray paints, varnishes and glazes that are
undiluted or slightly diluted. Detailed information is available in the technical data sheet
of the manufacturer (
1) Stir the material up and put the required amount into the paint container.
Sprayed material
Glazes
Wood preservatives, mordants, oils, disinfection agents,
plant protective agents
Paints containing solvents and water-soluble paints,
primers, spray films, vehicle coating paints, thick-film glazes
2) If the convey capacity is too low, add 5 - 10% dilution step-by-step until the convey
capacity fulfils your requirements (observe maximum permissible dilution according
to manufacturer's instructions).
General instruction
Description (Fig. 1)
Internet download).
Thinning recommendation
2) Air cap
4) Seal
6) Container (600 ml)
8) Container (150 ml)
10) Gun body
12) Material quantity regulation
(undiluted with Flexio)
GB
undiluted
undiluted
dilute by 0 - 10%
5
Publicité
