Important - Peg-Perego Carrello Team Notice D'emploi

EN_English
Thank you for choosing a Peg-Pérego product.
WARNING!
_ IMPORTANT: Keep these instructions for future
reference. Read and keep them for safety use.
The child's safety could be at risk if these
instructions are not followed.
_ This product was designed for the transport of 1 child
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ This product is approved for children from birth up to
a weight of 15 kg in the seat.
_ For new born babies is recommended to use the
backrest in the most reclined position.
_ This product was designed for use in combination
with Peg-Perego Ganciomatic products : Carrello
Team + Seggiolino Pop Up is approved for children
from birth up to 15 kg of weight ; Carrello Team +
Primo Viaggio (0+ group) is approved for children
from birth up to 13 kg of weight / Carrello Team +
Navetta is approved for children from birth up to 9 kg
of weight.
_ When used in combination with pram body : this
product is suitable for a child who cannot sit up by
itself, roll over and a cannot push itself up on it's
hands and knees. Maximum weight of the child : 9 kg.
Don't apply and don't use any different mattress of
that specified by the Manufacturer in the Instruction
Manual of pram body.
Any carrying handle (if present) shall be left out of the
pram body during use.
_ When used in combination with car seat (0+ group ),
this vehicle does not replace a cot or a bed.
Should your child need to sleep, then it should be
placed in a suitable pram body, cot or bed.
_ WARNING! Ensure that all the locking devices are
engaged before use.
Check that the Peg-Perego Ganciomatic products are
correctly fixed to the item.
_ WARNING! Check that the pram body or seat unit or
car seat attachment devices are correctly engaged
before use.
_ WARNING! To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_ WARNING! This product is not a toy. Do not let your
child play with this product.
_ WARNING! The assembly and preparation of the
product must be carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING! Never leave your child unattended.
_ Always apply the brake when stationary.
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest ... ).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer's instructions regards the maximum
loads transportable.
_ The front bar (if present) is not designed to support
the child's weight. It is not designed to keep the child
in the seat and does not substitute for the waist belt.
_ Do not load the baskets over 10 Kg. Do not put
weight in the cup holder (if present) in excess of those
indicated on the cup holders themselves and never
hot drinks. Do not put loads of more than 0.2 Kg in
the hood pockets (if present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or recommended by
the manufacturer/distributor shall be used.
_ WARNING! Don't use the rain cover (if present)
on a product without a hood or parasol that can
hold it. Always use the rain cover only under adult
supervision. Don't use the rain cover indoors and
check to ensure the child is not to warm; do not
park the vehicle close to heat sources and keep well
away from the lighted cigarettes. Ensure that the rain
cover is not interfering with any moving parts of the
carriage/stroller. Always remove the rain cover before
folding your carriage/stroller.
_ WARNING! This product is not suitable for running or
skating.
_ Always apply the brake when loading or unloading
children.
_ WARNING! Do not add any mattress are not
approved by the manufacturer.
_ Do not use accessories which are not approved by
the manufacturer.
_ WARNING! Do not touch the fastening knob on
the Ganciomatic base unless required by specific
instructions.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website:
www.pegperego.com
INSTRUCTIONS
1 OPENING: Before opening the frame, remove (without
using blades) any die-cut cardboard.
Release the two tabs on the sides of the frame (fig_a). Lift
and rotate the handle (fig_b) until the frame opens
completely. Press the handle until it clicks (fig_c) and
check that the safety devices are properly secured by
lifting it in the opposite direction. WARNING: when
fastening the seat, press down on same to secure it
to the Ganciomatic base.
2 WHEEL ASSEMBLY: fit the front wheels by inserting
them until they click (fig_a) and then proceed
similarly with the rear wheels until they click (fig_b).
3 LOCKED OR SWIVEL FRONT WHEELS: to turn the front
wheels into swivelling wheels, move the side levers
towards the open padlock (fig_a). To lock the wheels,
move the levers towards the closed padlock (fig_b).
We recommend using fixed wheels on uneven terrain.
4 BASKET: there are two sip strips on the front of the
basket for its easy use (fig_a). The support tube can
be lowered on the back for better use of space (fig_b).
Furthermore, there are two convenient pockets in the
basket (fig_c).
5 BRAKE: press the brake lever to lock the frame (fig_a),
the frame is locked when the red symbol appears
(fig_b). To unlock the brake, proceed in reverse order,
the frame is unlocked when the symbol is fully green
(fig_b).
6 ADJUSTABLE HANDLE BAR: to adjust the height of the
handle bar, simultaneous pull up the side buttons
(fig_a), move the handle bar to the required positions
(fig_b) and release the buttons.
7 LOCK: fully lower the handle bar (fig_6).
Press the central safety lever with your thumb (fig_a),
grasp and lift the lock handle (fig-.b) to rotate the
handle bar forward until fully locked (fig_c).
8 To correctly lock, make sure the side hooks are fully
closed (fig_a). The chassis can be taken anywhere
(fig_b).
9 BASKET REMOVAL: detach and remove the two Velcro
strips under the front chassis footboard (fig_a). Lower
the hinges (fig_4a) remove the side flaps from the
buttons (fig_b) and unhook the buttons from the
eyelets (fig_c).
- 11 -