Important; Swivel Wheels - Peg-Perego pliko mini Notice D'emploi

Masquer les pouces Voir aussi pour pliko mini:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
EN_English
Thank you for choosing a Peg-Pérego product.
WARNING
IMPORTANT: Keep these instructions for future
reference. Read and keep them for safety use.
The child's safety could be at risk if these
instructions are not followed.
_ This product was designed for the transport of 1 child
in the seat.
_ Do not use this product for a number of occupants
greater than that intended by the manufacturer.
_ This product is approved for children from birth up to
a weight of 15 kg in the seat.
_ For new born babies is recommended to use the
backrest in the most reclined position.
_ WARNING Check that the pram body or seat unit or
car seat attachment devices are correctly engaged
before use.
Check that the Peg-Perego Ganciomatic product are
correctly fixed to the item.
_ WARNING The assembly and preparation of the
product must be carried out by an adult.
_ Do not use this product if there are parts missing or
signs of breakage.
_ WARNING Always use the restraint system. Always
use the five point harness. Always use the harness
crotch strap in combination with the waist strap.
_ WARNING Never leave your child unattended.
_ Always apply the brake when stationary.
_ WARNING Ensure that all the locking devices are
engaged before use.
_ WARNING To avoid injury ensure that your child is
kept away when unfolding and folding this product.
_ WARNING This product is not a toy. Do not let your
child play with this product
_ Do not insert fingers into the mechanisms.
_ Be careful not to hurt the child when adjusting the
mechanisms (handlebar, backrest ... ).
_ Any weights hanging on the handlebar or
handles could make the item unstable; follow the
manufacturer's instructions regards the maximum
loads transportable.
_ The front bar (if present) is not designed to support
the child's weight. It is not designed to keep the child
in the seat and does not substitute for the waist belt.
_ Do not load the baskets over 5Kg. Do not put weight
in the cup holder (if present) in excess of those
indicated on the cup holders themselves and never
hot drinks. Do not put loads of more than 0.2 Kg in
the hood pockets (if present).
_ Do not use the product near to stairs or steps, heat
sources, naked flames or dangerous objects within
reach of the child.
_ Only replacement parts supplied or recommended by
the manufacturer/distributor shall be used.
_ WARNING Don't use the rain cover (if present)
on a product without a hood or parasol that can
hold it. Always use the rain cover only under adult
supervision. Don't use the rain cover indoors and
check to ensure the child is not to warm; do not
park the vehicle close to heat sources and keep well
away from the lighted cigarettes. Ensure that the rain
cover is not interfering with any moving parts of the
carriage/stroller. Always remove the rain cover before
folding your carriage/stroller.
_ WARNING This product is not suitable for running or
skating.
_ Always apply the brake when loading or unloading
children.
_ WARNING Do not add any mattress are not approved
by the manufacturer.
The images referring to the textile details may
differ from the collection purchased.
For more information, consult our website: 
www.pegperego.com
INSTRUCTIONS
1 OPENING: to open the stroller, unhook the left hand
side lever (fig_a), hold the handles and at the same
time lift the stroller.
Check that the stroller has opened properly by
ensuring that the side hooks are well secured (fig_b).
2 If the hooks are not secured properly, press the seat
downwards (fig_c) until they click into place. Finally,
press downwards on PUSH with your foot (fig_d).
3 ASSEMBLING: to mount the front wheels, firstly check
that the washer is present, as shown in the figure, then
lower lever A and slip wheel B on until it clicks into place.
4 To mount the rear wheels connected by the brake cable,
place them with the brake facing externally (fig_a).
WARNING: ensure the hooks have clicked into place, as
in figure b.
5 Finally, hook the central element of the brake cable onto
the chassis, ensuring it clicks into place, as in the figure.
6 BASKET: to mount the basket, slip the loops over the
rear hooks 1 and 2 and the front hook 3 (fig_a).
ADJUSTING THE HANDLES: the height of the handles
can be adjusted. Press the little button behind the
handles and pull upwards. To lower the handles, do the
opposite (Fig. b).
7 SWIVEL WHEELS: In order to make the wheels swivel,
the lever (arrow 1) must be lowered. To secure the
wheels, move the lever to the opposite direction
(arrow 2). The rear wheels are fixed.
BRAKE: To set the brake on the stroller, lower the lever
on the rear wheel unit with your foot. To release the
brake, lift the lever (fig_b). When stationary, always
apply the brake.
8 HOOD: To fit the hood, click the fasteners onto the
appropriate points until you hear them click (fig_a).
Fasten the two side buttons as shown (fig_b - c).
Finally, button down the hood on the rear of the
stroller's backrest (fig_d).
9 The hood can be set to 2 positions, simply by pulling it
backwards or forwards.
10 5-POINT SAFETY HARNESS: to fasten, insert the two
buckles of the waist strap (with attached shoulder
straps, arrow a) into the leg divider strap until they
click into place (arrow b). To unfasten them, press the
button which is situated in the centre of the fastener
(arrow c) and pull the waist strap outwards (arrow d).
11 To tighten the waist strap, pull on both sides in the
direction of the arrow. To loosen it do the opposite.
12 It is possible to set the safety harness at 3 different
heights, depending on how tall the child is. As the
child gets bigger, the harness must be moved to a
higher position.
13 To adjust the height of the safety harnesses, release
the two buckles on the rear of the backrest.
Pull the shoulder straps towards you (arrow a) until the
buckles are released and insert them in the backrest
loops (arrow b). Remove the shoulder straps from the
sack (arrow c) and insert them in the most appropriate
buckle (arrow d), then reattach the two buckles
behind the backrest (arrow e). The buckles are securely
attached when a click is heard (fig f).
14 LEG REST ADJUSTMENT: The leg rest can be set in 2
different positions. To lower the leg rest, pull the two
side levers downwards and at the same time lower the
leg rest. To raise the leg rest, push it upwards until it
clicks into position (fig_a).
BACKREST ADJUSTMENT: to adjust the backrest, lift
the handle and recline it to the desired position. The
backrest can be adjusted into different positions (fig_b).
15 FOLDING UP: pull one lever followed by the second
lever upwards until you hear them click (fig_a); then,
hold the central handle (fig_b) and pull it upwards
until the stroller folds up.
- 12 -

Publicité

Table des Matières
loading

Table des Matières