Briggs & Stratton 1696828 Manuel De L'utilisateur page 20

Specifications
Specification Chart
The spark ignition system on this snowthrower complies with Canadian standard ICES-002.
Item
Armature air gap
Intake Valve Clearance
Exhaust Valve Clearance
Oil Capacity
Sparkplug gap
Engine power will decrease 3.5% for every 1,00 feet (300 meters) above sea level and 1% for every 10 degrees F (5.6 degrees
C) above 77 Degrees F (25 Degrees C). The engine will operate satisfactorily at an angle up to 15 degrees.
Power Ratings
The gross power rating for individual gasoline engine models is labeled in accordance with SAE (Society of Automotive Engineers)
code J1940 Small Engine Power & Torque Rating Procedure, and is rated in accordance with SAE J1995. Torque values are
derived at 2600 RPM for those engines with "rpm" called out on the label and 3060 RPM for all others; horsepower values are
derived at 3600 RPM. The gross power curves can be viewed at www.BRIGGSandSTRATTON.COM. Net power values are
taken with exhaust and air cleaner installed whereas gross power values are collected without these attachments. Actual gross
engine power will be higher than net engine power and is affected by, among other things, ambient operating conditions and
engine-to-engine variability. Given the wide array of products on which engines are placed, the gasoline engine may not develop
the rated gross power when used in a given piece of power equipment. This difference is due to a variety of factors including,
but not limited to, the variety of engine components (air cleaner, exhaust, charging, cooling, carburetor, fuel pump, etc.), application
limitations, ambient operating conditions (temperature, humidity, altitude), and engine-to-engine variability. Due to manufacturing
and capacity limitations, Briggs & Stratton may substitute an engine of higher rated power for this engine.
20
Engine Model 130000
.010 - .014 inch (,25 - ,36 mm)
.004 - .006 inch (,10 - ,15 mm)
.006 - .008 inch (,15 - ,20 mm)
18 - 20 oz(,54 - ,59 L)
.030 inch (,76 mm)
Engine Model 150000
.010 - .014 inch (,25 - ,36 mm)
.004 - .006 inch (,10 - ,15 mm)
.009 - .011 inch (,23 - ,28 mm)
18 - 20 oz (,54 - ,59 L)
.030 inch (,76 mm)
Engine Model 19J000
.008 - .016 inch (,2 - ,4 mm)
.005 - .007 inch (,13 - ,18 mm)
.005 - .007 inch (,13 - ,18 mm)
36 - 38 oz (1,0 - 1,1 L)
.030 inch (,76 mm)