Operation And Handling - CASO DESIGN FinoCompact Mode D'emploi

Disposal of the packaging
Caso believes in the importance of recycling
and has selected packaging materials that not
only protect your unit from damage during transit,
but can be recycled to minimize ecological impact.
Recycling the packaging materials preserves raw
materials and reduces waste. Take any packaging
materials that are no longer required to a recycling
collection point for proper disposal.
If possible, keep the original
PLEASE NOTE
packaging for the device for
the duration of the guarantee period in the event a
return in necessary.
Setup
Setup location requirements
In order to ensure the safe and trouble-free opera-
tion of the device, the setup location must fulfi l the
following prerequisites:
• The device must be set up on a fi rm, fl at and
horizontal surface with suffi cient load-bearing
capacity for the scale and the maximum weight
of the food that should be weighed.
• Do not set up the device in a hot, wet or
extremely damp environment or near
fl ammable material.
Rating plate
The rating plate with the performance data can be
found in the battery compartment on the bottom
of the scales.

11 Operation and handling

This chapter provides you with important notices
with regard to operating the device. Observe the
following notices to avoid dangers and damages.
Batteries
1. Open the battery cover.
2. Put in 2 neuwertige batteries.
(1,5V/ AAA – not included in delivery scope)
Make sure that you insert the batteries correctly
(+/- terminals).
3. Close the battery cover.
Replacing the batteries
When the batteries are low, the display will show the
error "Lo" and the scales will turn themselves off after
a short time. Change the batteries as described in
the "Replacing the batteries" section below. Remove
the batteries from the battery compartment if you
are not planning to use the scales for a longer period
of time.
Operation
Weighing
1. Remove the fi xing tape from the device, then
remove the weighing bowl / cover.
2. Place the scales on a hard, fl at surface.
3. Place the weighing bowl on the weighing
surface.
4. Press the "On/Off " button to switch the scales
on. The scales will be set to the last unit of
measurement you used and the display will
show 0.
5. Place the object to be weighed on the scale
surface.
6. The weight will appear on the display.
CASO FinoCompact
EN
11