Cadac SAFARI CHEF 2 Mode D'emploi page 8

• To replace the Jet: Remove the Fat pan (Fig. 9). Gently unscrew the burner assembly (Fig. 10). Remove the three screws from the heat
shield plate and remove the Heat Shield(Fig. 11), taking care not to damage the piezo electrode. The Jet can now be removed using a
suitable spanner (Fig. 12). Do not use pliers on the jet as this may damage the jet, making it unusable or impossible to remove. Screw
the new jet into the valve. Do not over-tighten as this may damage the jet.
• Reverse the above procedure to re-assemble the unit.
Replacing the Hose:
• The fitting of a hose is described in Section 5 - Fitting and replacing the hose and gas cylinder.
10. Returning the appliance for repair or service.
• Do not modify the appliance, as this could be dangerous.
• If you cannot rectify a fault by following these instructions, contact your local CADAC distributor for details on how to return the
product for attention.
• Your CADAC Safari Chef 2 is guaranteed by CADAC for a period of 2 years against factory fault.
Fig. 9
Jet
Fig. 11
6
GB
Fig. 10
Fig. 12