BADU EasyFit Eco VS Fiche Technique page 28

Pos: 34 /Technische Dokumentation/Pumpendatenblatt/Motorsteuerung/Eco/Eco VS/Übersicht möglicher Betriebs- und Fehlermeldungen @ 2\mod_1435673880513_370.docx @ 33782 @ @ 1
Overview of possible operating and error messages
If an error occurs, the motor switches off permanently and a
message is displayed. Exception: "Under voltage" if there is a
failure or the power supply switches off. In this case the motor
restarts when the power supply is switched on again.
If an error occurs, the system must be disconnected from the
power supply. See chapter 2.2 of the original operating manual
"Non self-priming and self-priming pumps with/without plastic
lanterns (AK version)".
Pos: 35 /Technische Dokumentation/Allgemeine Module/####halbe Leerzeile #### @ 3\mod_1437024231169_0.docx @ 36332 @ @ 1
Pos: 36 /Technische Dokumentation/Pumpendatenblatt/Motorsteuerung/Eco/Eco VS/Tabelle Fehlerübersicht @ 2\mod_1434607376032_370.docx @ 33427 @ @ 1
Error No.
Err 1
Err 2
Err 3
Err 4
Err 5
Err 7
Err 10
Err 20
Err 64
Err 97
Err 98
Pos: 37 /Technische Dokumentation/Allgemeine Module/#### Seitenumbruch #### @ 0\mod_1426069111812_0.docx @ 891 @ @ 1
Pos: 38 /Technische Dokumentation/Pumpendatenblatt/Punkte aus mitgeltende Dokumente @ 3\mod_1437029935278_370.docx @ 36363 @ @ 1
The following points refers to the related documentation!
Pos: 39 /Technische Dokumentation/Pumpendatenblatt/Deckel/Saugsieb demontieren bzw. montieren @ 3\mod_1437025205014_370.docx @ 36347 @ @ 1
8.1 Installing or removing the cover/strainer basket
Pos: 40 /Technische Dokumentation/Pumpendatenblatt/W72.40.007-1-P @ 3\mod_1437124658247_0.docx @ 36452 @ @ 1
W72.40.007-1-P
=== Ende der Liste für Textmarke Inhalt ===
EN 28
Description
Undervoltage intermediate circuit
Overvoltage intermediate circuit
Supply voltage too low/too high
Temperature at the power electronics too high
Overtemperature motor
Overcurrent electronics
Current measurement faulty
Abortion during start-up, overload
Short-circuit electronics
Simultaneous occurrence of several errors or
faults
Connection to the control unit faulty
2
1
3
11|2016