NewAge Products 65902 Mode D'emploi page 31

Double Side Burner Control Knob and Manual Lighting
ELECTRIC IGNITION for DOUBLE SIDE BURNER
1. Read and complete PRE-GRILL checklist.
2. Make sure all control knobs are set to off.
3. Always light the burners with lid open.
4. Turn fuel supply on.
5. Push in, turn the control knob to the ignition
point ( )and. hold in for 5 seconds until
the burners ignite. It will immediately be on
high.
6. Once the burner is lit, adjust the temperature
using the Max -to- Min settings.
MANUAL LIGHTING:
If the burners fail to light after a couple of
attempts, it can be lit using the supplied match
lighting stick. Follow the steps below for manual
grill lighting.
1. Read and complete PRE-GRILL checklist.
2. Make sure all control knobs are set to off.
3. Always light side burner with lid open.
4. Turn fuel supply on.
5. Place a match in the aligator clip on the match holder and light the match.
6. Guide the match holder, with lit match, close to the holes surrounding burner.
7. Push the left control in and turn it to HIGH to ignite the left burner. Check that the flame is lit .
You should see a flame.
8. Repeat steps 4 through 6 for the remaining burner. If any of the burners fails to ignite during
the lighting process, within five seconds, stop, turn the burner control knob to OFF and wait five
minutes to allow the gas to clear before you try again.
Figure 1.
Ignition
High
Temperature
A.
1
2
www.newageproducts.com
Point
Low
Temperature
1
2
Figure 2.
OFF
31