Propane Installation - NewAge Products 65902 Mode D'emploi

Propane Installation

Open the doors of the cabinet, and pull out
1
the propane tray.
Connect brass fitting on Type 1 regulator hose
3
to gas inlet on Double Burner manifold.
3
Note: In order for the LED lights to be
!
operational, the Double Side Burner needs to
5
be plugged into a GFCI outlet installed by an
electrician.
GRILL ELECTRICAL REQUIREMENTS:
110 VAC 60 Hz
12
2
4
!
5
GFCI
www.newageproducts.com
Place and secure a 20 lb. LP tank into pullout
tray ring and tighten wing bolt to engage tank
clamp on to base of propane tank.
Rotate clock wise
shown from below
for clairity
Attach regulator hand wheel to the tank.
Clockwise to tighten, counter-clockwise to
loosen.
WARNING!The grill and cabinet must have a
minimum clearance from combustible materials.
Refer to below figure for clearance dimensions.
* The outdoor cooking gas appliance
shall not be used under overhead
combusible construction
Side - 10" Clearance
Rear - 18" Clearance
18 Inches
10 Inches