Natural Gas Connections - NewAge Products 65902 Mode D'emploi

Masquer les pouces

Table des Matières

Les langues disponibles

Natural Gas Connection

WARNING

used to connect this product.

• Calculate the total BTU output of all equipment and refer to Gas Supply Line Runs for allowable run

distances for ¾ inch pipe. Failure to meet these minimum requirements may reduce performance of the grill

and any other appliances running on that supply line.

• Always keep supply line runs as short as possible.

• A gas shut-off valve must be installed in an easily accessible location by a qualified licensed gas fitter.

• The outdoor cooking gas appliance and its individual shut-off valve must be disconnected from the gas

supply piping system during any pressure testing of that system at test pressures in excess of 0.5 psi (3.5

kPa).

•The outdoor cooking gas appliance must be isolated from the gas supply piping system by closing its

individual manual shut-off valve during any pressure testing of the gas supply piping system at test

pressures equal to or less than 1/2 psi (3.5 kPa).

• Keep threading compound off of the first two pipe threads to avoid having any small pieces of compound

break loose and clog a burner valve or orifice. Do not use threading compound on any flare fittings.

For built-in installations, it is recommended that any flexible pipe used be kept as short as possible.

For freestanding units using natural gas, NewAge strongly recommends using a quick disconnect kit.

This Quick Disconnect kit, is included with purchase.

NOTE:This product must be installed by a licensed plumber or gas fitter when installed within the State of

Massachusetts.