Gas Connections - NewAge Products 65902 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OXIDIZATION Removal
If you have oxidation there are a few steps to take to bring your stainless steel cabinets back to "as new"
condition. Apply clean water with a cleaning sponge and rub gently in the direction of the grain. If the mark
won't shift, it may be necessary to use a stainless steel cleaner, in which case apply the cleaner and rub
gently. After cleaning it is important to rinse the stainless steel with clean fresh water and buff with a soft
cloth. Remember to always rub with the grain, NEVER across as you will ruin the fi nish, and the stainless can
lose its shine. If you must use a scourer, usea plastic scrub pad with no metal content.
Never connect a gas line directly to the gas appliance. A pressure regulator must
be installed on all gas equipment. All local codes require a pressure regulator
and NewAge supplies the correct regulator with your gas appliance. Removing or
failing to install the pressure regulator can result in fire, and serious personal injury
and will void the warranty. This gas appliance is designed for non-combustible
!
enclosures only, and must be installed and serviced by a qualified installer to local
codes.
As indicated on the rating plate, this gas appliance is designed to operate with gas
WARNING
supply pressures of 11" WC for Propane and 7" WC for Natural Gas. For installations
where the gas supply pressure exceeds these requirements, a regulator must be
installed upstream of the grill's components. If the gas supply pressure is lower than
these requirements, the unit will be under-fired and will not reach the maximum
temperatures. Ensure that the supply line size complies with local and/or national
installation codes.
The Double Side Burner is factory set to use natural gas (NG). The Side Burner can be converted to use
propane gas. See :Converting from Natural Gas to Propane on page 11. It is critical that the gas you use
matches that which the grill was set up for. You can verify that by checking the rating plate.
Rating Plate - Lists serial numbers, model numbers, and gas type
The rating plate will be attached to the Double Burner by chain.
Remove the drip tray, and locate rating plate inside of cabinet.
Ensure that the gas supplied meets with the minimum pressure requirements. Do not operate the Burner on
any gas other than that for which the grill has been set.
Both the regulator and the manifold orifices have been tuned for the type of gas specified on the rating
plate. Converting to a different type of gas requires a conversion kit, supplied from NewAge and must be
installed by a qualified technician. All installation and all installation parts must conform to local codes
with the National Electrical Code, ANSI Z223.1/ NFPA 70 latest edition and the National Fuel Gas Code,
ANSI Z223.1/NFPA 54 in the U.S. and CGA-B149.1/.2 in Canada. Canadian installations must conform to
CGA-B149.1/.2 natural gas/propane installation code. (Canada)

Gas Connections

www.newageproducts.com
Fuel
WC Min Under
Full Load
NAT GAS
7 in WC
LP
11 in WC
Water Column Requirements
15

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

65012652126541265609

Table des Matières