Cut-Out Dimensions - NewAge Products 65902 Mode D'emploi

Cutout Dimensions for Built-in
The installation must conform with local codes or, in the absence of local
codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54, Storage
and Handling of Lique ed Petroleum Gases, ANSI/NFPA 58; or Natural
Gas and Propane Installation Code, CSA B149.1; Propane Storage and
Handling, CSA B149.2; or the Standard for Recreational Vehicles,
ANSI A119.2/NFPA 1192; and Recreational Vehicle Code,
CSA Z240 RV Series, as applicable.
MODEL
16 " 14 1/4"
65902
SIDEBURNER
153mm
362mm
OUTDOOR GFI ELECTRICAL OULET
RECOMMENDED - LOCATE ON SAME SIDE
OF GRILL AS ROTISSERIE BRACKET.
ELECTRICAL OPENING
GAS INLET OPENING
5"
127mm
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED ON
EACH END OF CABINET.
5"
127mm
MAXIMUM
MINIMUM 10 SQ IN (65 SQ CM)
OF VENTILATION REQUIRED ON
EACH END OF CABINET.
Allow access in order to
connect or disconnect
propane hose regulator to
propane tank.
Secure 20 lbs propane tank to
interior of built in cabinet.
OPENING DIMENSIONS
W D H
21 1/4" 10 3/8"
540mm 264mm
www.newageproducts.com
!
WARNING
Cabinet frame, cabinet side panels and
counter top must be made from
non-combustionable material.
D
2 3/4"
70mm
H
W
5"
127mm
MAXIMUM
1"
25.4mm
MAXIMUM
!
!
WARNING
A propane tank can not
be stored below the gas grill.
Only 1 tank in service should
be used with the grill.
Note to Installer:
A built-in appliance for use with
a remote LP gas supply system
where the installer constructs the
propane cylinder enclosure. The
installer must provide detailed
instructions and diagrams that
comply with clauses 4.6.1-4.6.5
of the ANS Z223.1 Code.
All built-in appliances must use
rigid pipe, semi-rigid tubin, or a
connector complying with the
34"
standard for Connectors for Gas
864mm
Appliances, ANS Z21.24. CSA 6.10,
RECOMMENDED
or Standard for Connectors for
Outdoor Gas Appliances and
Manufactured homes, ANS Z21.75.
CSA 6.27, for the appliance which
are connected to xed fuel piping
system (Natural Gas).
The appliance, when installed,
must be electrically grounded in
!
accordance with local codes or, in
the absence of local codes, with
the National Electrical Code, ANS
WARNING
/NFPA 70, or the Canadian
Electrical Code, CSA C22.1.
13