Electric Power Supply Requirements; Gas Supply - Forno FFSGS6275-30 Guide D'installation

CAUTION
Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation.
Verify proper operation after servicing.
ELECTRICAL SHOCK HAZARD
Disconnect electrical power at the circuit breaker box or fuse box before installing the appliance. Provide appropriate
ground for the appliance. Use copper conductors only. Failure to follow these instructions could result in serious injury or
death.
Electric Power Supply Requirements
Shortest connection from hard pipe stub
location to range hook-up.
Gas Supply
Installation must comply with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1 /
NFPA 54. In Canada, installation must conform to the current natural Gas Installation /code, CAN 1-1.1-M81 and with local
codes where applicable.
This range has been design-certified according to ANSI Z21.1b-2012 latest edition.
TYPE OF GAS:
NATURAL GAS
Supply Pressure
Minimum Supply Pressure
Max Regulator Pressure
LP GAS
Supply Pressure
Minimum Supply Pressure
Max Regulator Pressure
WARNING
Do not obstruct the flow of combustion air into the range and ventilation air away from the range
Area allows for flush installation
with through-the-wall connection
of pipe stub/shut-off valve and rear
wall 120V outlet.
Area allows for flush installation with through-the-floor
connection of pipe stub/shut-off valve
WC
4"
6"
14", 0.5 psi (3.5 kPa)
WC
10"
11"
14", 0.5 psi (3.5 kPa)
11