Bodet Time Style 5S Notice D'installation Et De Mise En Service page 6

2.1.2 Mounting with back cover
According to the model of the clock make the cut-out following the dimensions listed in table below:
Style 5S OP
Style 7S OP
Dimensions in mm
a) Insert the back cover in the cut-out in order to mark the position of the 6 mounting screws.
b) Remove the back cover and drill 2 holes Ø 6 mm (
mounting.
c) Drill 4 holes Ø 10mm (
d) Feed the power cable and the synchronisation cable throught the cut-out and cable glands of the
back cover.
e) Apply a silicone seal between the back cover (fixing brackets) and the wall.
f) Fix the back cover to the wall with the 2 screws Ø 4mm.
g) Connect the clock, adjust the brightness (page 7) and set the time (refer to page 9).
h) Apply a silicone seal between the back cover and the clock.
i) Fix the clock to the back cover with the 4 screws Ø 4mm.
6
A B
400
46
440
) to make room for the 4 clock mounting rivets.
Y
Installation with the back cover
C
365
404
Y
X
Y
) to insert the wall plugs for the back cover
X
Back cover mounting screws Ø4mm
D E
68 107
85 123
EN