What To Do If - Bodet Time Style 5S Notice D'installation Et De Mise En Service

IX

– What to do if...

What to do if...
There is no synchronisation
after installation.
The NTP slave time is
incorrect.
There is no DHCP server on
the network.
One of the Style clocks
does not switch on or
repeatedly reboots.
20
1) The signal type sent by the master clock is the same as the
clock's signal type.
2) The NTP server is on the same network as the slave
(IP addresses, subnet mask and gateways).
1) The time zone selected on the web server is correct.
1) The default network configuration on the clock is as follows:
– IP: 172.17.30.110
– MASK: 255.255.0.0
– GATEWAY: 0.0.0.0
– DNS: 0.0.0.0
1) The maximum power from the PoE switch is sufficient to supply
all of the clocks connected to the switch.
2) Cable length is less than 100 metres (refer to the network wiring
standards).
3) All switch outputs are PoE-compatible.
Check that...
EN EN