BOMANN CL 6044 QC CB Mode D'emploi page 87

Maximum Temperature and Speed (
Pressing the TURBO button activates or deactivates the Turbo function.
This allows the adjusted temperature to be attained as quickly as pos-
sible.
Mildew / Self-cleaning (
1. To activate self-cleaning mode, press the OPTION button.
2. Use the arrow buttons to select
on the remote control display.
3. Confirm your selection using the OPTION button.
4. Use the OPTION button to switch off the "
Automatic Temperature Calculation (
Automatic temperature calculation my means of a sensor in the remote
control. Ensure that the remote control is not exposed to sources of heat
such e. g. lamps.
" press the OPTION button.
1. To activate "
2. Use the arrow buttons to select
the remote control display.
3. Confirm your selection using the OPTION button.
4. Press the OPTION button again to switch off the "
Cleaning and Maintenance
WARNING:
Make sure no water penetrates the openings on the
appliance during cleaning. Danger of electric shock or
fire.
CAUTION:
• Maintain your appliance regularly to ensure its safe and efficient
operation.
• All cleaning and maintenance work must be performed by a certi-
fied refrigeration and air conditioning company. Improper application
shall result in expiry of the warranty.
Cleaning and Exchanging the Filter
1. Open the front panel in the direction of the arrow.
2. Raise the front cover with one hand, use the other hand to remove
the dust filter.
CL6044CB_IM
)
)
and until " " appears
" function.
)
and until " " appears on
" function.
3. Clean the filter with water. If heavily soiled, use warm water to clean
(not above 45 °C). Then leave the filter to dry.
4. Reinsert the air filter.
5. Close the compartment cover.
Cleaning the Interior Unit
1. Open the front plate of the appliance and remove the hinges to facili-
tate cleaning.
2. Clean the interior unit using a cloth and water (not warmer than 40 °C).
CAUTION:
• Do not spray cleaning agents on the appliance.
• Do not immerse the appliance in water: the electronic components
can be damaged.
• Do not use a wire brush or any abrasive items.
Cleaning the Exterior Unit
If the air inlet on the exterior unit is blocked, remove any leaves or other
waste material present and then remove any remaining dust using com-
pressed air or a little water.
Changing the Battery
NOTE:
Use only new batteries. Only remove the batteries from the remote
control when the air conditioning unit is switched off.
87
17.12.20