Shindaiwa DH2200ST Manuel D'utilisation page 22

Maintenance and care
Cleaning silencer
1. Two bolts
2. Silencer
Check fuel system
1. Fuel tank cap
Check spark plug
a: 0.6 - 0.7 mm
3. Exhaust guide
1. Carbon deposits in silencer and exhaust guide will cause a
drop in engine output and overheating. Clean deposits from
silencer and exhaust guide.
2. Tighten two bolts.
Check before every use.
After refuelling, make sure fuel does not leak or exude from
around fuel pipe, fuel grommet or fuel tank cap.
In case of fuel leakage or exudation there is a danger of fire.
Stop using the machine immediately and request your dealer
to inspect or replace.
Check plug gap. Correct gap is 0.6 mm to 0.7 mm.
Inspect electrode for wear.
Inspect insulator for oil or other deposits.
Replace plug if needed and tighten to 15 N•m - 17 N•m (150
kgf•cm to 170 kgf•cm).
20